Swirl pics-Pad recommendations?

[greg72982]

Took some pics today of my swirls. I going to use the PC7424XP with the Wolfgang Twins, and following it up with the WG deep gloss paint sealant. Do you think the orange pad will be sufficient for the cutting phase?

First was taken from a distance with out anyhting for the cam to focus on:


The other four were all taken on the driver side in random locations: the hood, the side near the rear window, the spoiler/rear fender, and the last of the driver door above the door at the roof.








Another thing I can see at night when headlights hit it during the days and certain angles from the sun are some "holograms." The are hand induced as I hit the car with some Zaino products back in early June and probably wasn't as careful as I needed to be. I would imagine since they are hand induced a machine will take them out as well?? Thanks in advance.

[rider9195]

Try a test spot with the Total Swirl Remover and the orange pad. Look at it in the sun and if the holograms are removed and you are happy continue on. But if not, get some M105 to try on the orange pad. Maybe even pick up a pack of Surbuf pads.

[Mike Phillips]

Took some pics today of my swirls. I going to use the PC7424XP with the Wolfgang Twins, and following it up with the WG deep gloss paint sealant.

Do you think the orange pad will be sufficient for the cutting phase?

Yes. More than sufficient enough. Might even be able to do it with a less aggressive pad like a polishing pad. I would test the polishing pad first because if you can remove the swirls with the polishing pad you'll be further ahead towards your goal versus using a aggressive cutting pad.


The key for any swirl removal job is to not tackle to large an area at one time.

Read through this before starting, it will help you avoid the common mistakes...

DA Polisher Trouble Shooting Guide


This too...

DA Polisher Articles - Help for Newbies to Machine Polishing



Remember to clean you pads often...

Why it's important to clean your pads often...

How to clean your foam pad on the fly

Wet Buffing Technique

How to prime a foam pad when using a DA Polisher



I talked to a guy today that was trying to apply and then remove product at the same time with their PC, that's not going to work very well.

After buffing a section, immediately wipe off any residue.

[greg72982]

Well if I don't have to use the orange I won't, my understanding is white would be the next level down?


Thanks for the links also...