Thanks: 0
Likes: 0
Dislikes: 0
-
Newbie Member
Re: Just Picked Up GG6 Now need Pads.
i am planing to get my car ready for the winter before the bad weather hits us up here in Jersey. I going to use some Wolfgang Polish enhancer and then seal it with Wolfgang sealant 3.0 . Thats the plan.
-
Re: Just Picked Up GG6 Now need Pads.
-
Regular Member
Re: Just Picked Up GG6 Now need Pads.
I do not mean to thread jack, but I am in the same situation as the OP. I recently purchased a GG6 with 5in plate and hydrotech essential pad kit. I was orginally going to get the CCS pads because of the their user friendly nature, for a first time machine user. Now I am second guessing myself. I will be doing personal vehicles with very lite to moderate swirls and scratches.
I noticed the ccs pads have a bigger selection in pads to where you can fine tune your cutting, polishing and waxing. where as the hydrotech only gives you 3. I going off the less aggrasive approach I have been reading here. Did I make a mistake going with HT vs ccs?
-
Junior Member
Re: Just Picked Up GG6 Now need Pads.
I ordered the GG6 with LC "5 packing plate and a 6 pack of LC ThinPro "5.5, they're on the way.. I did a research and looks like it's the perfect combo.
-
Super Member
Re: Just Picked Up GG6 Now need Pads.
Originally Posted by Scoobertin
I do not mean to thread jack, but I am in the same situation as the OP. I recently purchased a GG6 with 5in plate and hydrotech essential pad kit. I was orginally going to get the CCS pads because of the their user friendly nature, for a first time machine user. Now I am second guessing myself. I will be doing personal vehicles with very lite to moderate swirls and scratches.
I noticed the ccs pads have a bigger selection in pads to where you can fine tune your cutting, polishing and waxing. where as the hydrotech only gives you 3. I going off the less aggrasive approach I have been reading here. Did I make a mistake going with HT vs ccs?
no need to 2nd guess yourself, "the tangerine foam is made for light to moderate defect removal and polishing. it has the cutting power just below that of the lake country orange light cutting pad, and the tangerine pad leaves a finish like you'd achieve with a gray finishing pad."
Originally Posted by c7stingray
I ordered the GG6 with LC "5 packing plate and a 6 pack of LC ThinPro "5.5, they're on the way.. I did a research and looks like it's the perfect combo.
-
Regular Member
Re: Just Picked Up GG6 Now need Pads.
Originally Posted by VISITOR
no need to 2nd guess yourself, "the tangerine foam is made for light to moderate defect removal and polishing. it has the cutting power just below that of the lake country orange light cutting pad, and the tangerine pad leaves a finish like you'd achieve with a gray finishing pad."
OK good, I did research on pads but there is so much info and opinions, it can be a hard decision to make. I just figured the hydrotech was a good in the middle of the pack between the ccs and thin pros. I am all new to this. I have been a hand and otc product guy. Never realized there was this much to detailing. Can be overwhelming at first. Decided to step up it up and see what I can accomplish personally.
-
Super Member
Re: Just Picked Up GG6 Now need Pads.
As VISITOR said don't second guess yourself on what pads you ordered as they are quality products. However, make sure you order enough pads--you can set yourself up for failure by trying to do each step with too few pads. See the link at post #10 to Mike Phillips post on this subject.
-
Super Member
Re: Just Picked Up GG6 Now need Pads.
as ski2 mentioned, you can never have enough pads and variety at that because you will come across different situations where no one pad will work in every situation. you can never have enough pads and microfiber towels...
-
Newbie Member
Re: Just Picked Up GG6 Now need Pads.
How many pads would you recommend having as a begginer to start out with. Is 12 LC Flats 5 1/2 pads a good number to start at ? And as i continue polishing and learning add more to my collection of pads ?
-
Regular Member
Re: Just Picked Up GG6 Now need Pads.
Yup, I read mikes post about the number of pads. I have 5 blue, 6 orange and 3 reds to start out. I will try these pads for awhile and see what it is like and switch it up if need to.
Similar Threads
-
By TTQ B4U in forum Off-Topic
Replies: 47
Last Post: 06-25-2020, 06:36 AM
-
By Justin at Final Inspection in forum Auto Detailing 101
Replies: 14
Last Post: 06-10-2015, 11:05 AM
-
By NeverEnough in forum Auto Detailing 101
Replies: 2
Last Post: 05-23-2013, 08:43 AM
-
By alko in forum Auto Detailing 101
Replies: 11
Last Post: 09-15-2011, 11:27 AM
-
By ALLN1WASH in forum Auto Detailing 101
Replies: 39
Last Post: 05-26-2011, 06:36 AM
Members who have read this thread: 0
There are no members to list at the moment.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|
S |
M |
T |
W |
T |
F |
S |
31 |
1
|
2
|
3
|
4
|
5
|
6
|
7
|
8
|
9
|
10
|
11
|
12
|
13
|
14
|
15
|
16
|
17
|
18
|
19
|
20
|
21
|
22
|
23
|
24
|
25
|
26
|
27
|
28
|
29
|
30
| 1 | 2 | 3 | 4 |
|
Bookmarks