So I’ve recently purchased some Deep Gloss Paint Sealant and I had a few questions.
1. How long should I let the product flash on my paint. Can I coat the whole car then remove it all in one shot?
2. Can I use this on my glass?
So I’ve recently purchased some Deep Gloss Paint Sealant and I had a few questions.
1. How long should I let the product flash on my paint. Can I coat the whole car then remove it all in one shot?
2. Can I use this on my glass?
1. Wash your vehicle using Wolfgang Auto Bathe or your favorite shampoo. Dry completely.
2. For the best results, use a paint cleanser like Wolfgang Paintwork Polish Enhancer to remove mild imperfections and wax build-up.
3. Apply Wolfgang Deep Gloss Paint Sealant 3.0 over the entire vehicle either by hand or with a machine. If applying by hand, use a yellow foam applicator. If applying by machine, use a blue finessing pad. Using a dual action polisher, set the maximum speed to 4.5 and work in overlapping sections until the entire vehicle is covered. Apply a very thin, even coat.
4. Once the vehicle is covered, wait 30-45 minutes before buffing off the sealant. Use a microfiber towel or a microfiber bonnet on your polisher.
5. This product is moisture-sensitive. In order to achieve a slick, durable finish, Wolfgang Deep Gloss Paint Sealant 3.0 must cure for at least 12 hours before being exposed to moisture. Do not apply sealant before dusk because dew will interfere with the adhesion to the paint. Park your vehicle in a garage or under a shelter while it is curing, if possible.
6. Use Wolfgang Deep Gloss Spritz Sealant to boost the gloss and protection any time with even more reflective Super Polymers.
"You can avoid reality, but you cannot avoid the consequences of avoiding reality." - Ayn Ran
I am not sure about the glass, but I applied the WDGPS by hand on my truck and I let it sit for about 1/2 hour. I removed it with a microfiber bonnet on my orbital polisher with a wool leveling pad. I applied the product in October and it is still holding up well. The water beads on the top surfaces and rolls off of the sides. I am glad that I made the decision on the sealant especially after the winter that we had.
I do the whole car with a DA and apply a very thin coat. I do use it on glass and it works well. I let it haze/sit for at least 45 minutes and it wipes off with basically zero effort. Do a swipe test with your finger before removing it. Make sure it doesn't streak.
I would seriously recommend DA application. You really need very little. I've used it probably 10 times and still have more than half a bottle.
It's an amazing product. Looks great and lasts for a long time if properly cared for.
Bookmarks