I had a customer contact me concerned about a scuff mark on the front corner of the bumper. After hearing a bit about the story the owner pulled into a parking spot too close to a wall.
To start off with the least aggressive method D155 LT and Meguiar's red C2100 call was used. Nothing.
At this point I would grab some kind of an adhesive remover but to my surprise I was out.
Not wanting to run out to the store to grab some, I decided to see if CarPro Tar-X would do the trick. At first it didn't seem to work but after a minute I began to run the areas by hand and saw that the mess began to turn milky and liquefy. I combined Tar-X with a small piece of clay and it made extremely short work of the affected area. (also started to liquefy the clay bar.)
I don't have any pictures of the during process of using that combination but wanted to share an experience.
After that, the mess left behind was cleaned up with Eraser and polished out with FG400, SF4000, and protected with Endless Shine.
Hopefully I see the vehicle in the future to give it a proper detail.
Bookmarks