Reflect Silver VW Polo 9N3 - Detailed by Lawrence

**lawrenceSA** · 07-24-2013, 01:19 AM

Originally Posted by noslef

I especially like your posts not only because of the awesome work, but also because a lot of the cars you feature are not available over here and it's great to see something different.

Thanks for your kind comments.

And I feel ya..... as I am in the same boat over here, with us not having a lot of the cars you guys have over there too. Always interesting to something I have never seen before

**eff** · 07-24-2013, 07:23 PM

What place did they come in at the Baja 500? I've never seen so much dirt on a car. Nice work getting that corrected.

**Mike@DedicatedPerfection** · 07-24-2013, 10:38 PM

Incredibly thorough job in all areas and well documented write up as always.

Well done good sir.

**lawrenceSA** · 07-25-2013, 01:47 AM

Originally Posted by eff

What place did they come in at the Baja 500? I've never seen so much dirt on a car. Nice work getting that corrected.

Thanks

**lawrenceSA** · 07-25-2013, 01:47 AM

Originally Posted by smack

Incredibly thorough job in all areas and well documented write up as always.

Well done good sir.

Thank you very much Mike - truly appreciate the kind words

**cartman57** · 07-25-2013, 06:05 AM

Stunning results as usual and always enjoy your write ups.
Hopefully the owners of all the vehicles you detail will take the time for continued care after your work.

**sproketser** · 07-25-2013, 06:25 AM

Top job again mate ! Did you use some pressure washer also in the door
shuts & gas flaps . & or you used some brushes in there .

Must have took lots of hours to do this great job . Keep it on mate .

**lawrenceSA** · 07-25-2013, 10:46 AM

Originally Posted by cartman57

Stunning results as usual and always enjoy your write ups.
Hopefully the owners of all the vehicles you detail will take the time for continued care after your work.

Thanks.

Well I have been selling them a little starter kit with the detail.... Wash mitt/drying towel/shampoo...and teaching them the 2bm. I also try to educate them a bit about paint care so that when they leave they are equipped to maintain their vehicles properly.

Hopefully this will encourage them to do it right....

Sent from my iPad using Tapatalk HD

**lawrenceSA** · 07-25-2013, 10:50 AM

Originally Posted by sproketser

Top job again mate ! Did you use some pressure washer also in the door
shuts & gas flaps . & or you used some brushes in there .

Must have took lots of hours to do this great job . Keep it on mate .

Thank you for your kind words.

My usual routine with these areas is simply to spray some APC on, brush over the whole area with a soft brush, let it dwell for as long as I can before it dries out (which is driven by the weather on the day), and then rinse it with a gentle flow of water out the hose. Dry, seal and you are done.

This one took around 23hours.

Sent from my iPad using Tapatalk HD

**sproketser** · 07-25-2013, 11:04 AM

Originally Posted by lawrenceSA

Thank you for your kind words.

My usual routine with these areas is simply to spray some APC on, brush over the whole area with a soft brush, let it dwell for as long as I can before it dries out (which is driven by the weather on the day), and then rinse it with a gentle flow of water out the hose. Dry, seal and you are done.

This one took around 23hours.

Sent from my iPad using Tapatalk HD

Hey thanx for the comeback mate !