Water would just not penetrate the thick layer of wax even if used from a pressure washer. The wax would break the surface tension immediately and water would bead up.. Beading will be awesome...
Another hyperwash fan here. Amazing lubricity and cleaning ability. And at that dilution, hits the nail on its head. Clean fragrance too. 15ml in 10lts of water is all that is needed to clean the...
In case the PBL coating is not immune against compositions such as spotless,it would be better if the same is mentioned in the product description so that customers are aware of what they use on...
I understand your point . My thinking was in a different direction . Spotless used on CQuartz does not remove the coating . Hence the conclusion that pinnacle coating is not immune to spotless.
Applied a layer last week and must say it goes on and off real smooth .A moist foam applicator will ensure that the applicator does not grab the paint during application.I observed that the...
Have a Karcher K3.550 which is approximately 1750 PSI which comes only with a fanning lance which would not harm the paint even if distance is less than a feet
Yea it's nearly 40 degree Celsius here in South India [emoji3]. Water is sheeting well. Especially on the vertical panels where hardly any water stays a minute after rinsing
A couple a weeks back I detailed my Hyundai i20 . Below are the steps I followed
1. Wash with megs hyper wash
2. Ironx and tar x and Clayed using Elastrofoam.
3. Applied poor boys...
Now that you have committed a price. Stick to it. Do not bother much. Tell the customer at when they come to pick the car that this was a one time special price.
From my experience, the clay starts to grab the surface even with sufficient lube when it's reached the end of its life. Also starts leaving clay residue on the surface which is a PITA to remove.