Just use the applicator that comes with the V2 kit to apply? How about the reccomended microfiber towels to use for removal? I assume you have to get rid of them using Cosmic V2 and not High Gloss?
I worked on the grey metallic Honda Civic, polishing with Jescar Correcting Compound on Orange Pads. I found with the Flex 3401, that the thin Lake Country worked best with this polish and polisher....
I blow out the nooks and crannies, and drive the water off the car if reasonably possible. Then dry with Waffle Weave towel and some QD. Wheels/tires/lights/trim/mirrors... all that before wiping...
Eric, thanks and I will spot sand and remove the rust. I'm not at the "live with it" stage yet, but will eventually. Until then I'm going to use this car for some glaze/LSP testing. It's outside...
I'm a DIYer and I don't have a paint meter. Not too long ago we bought a 3rd car (for future teen drivers), a 2014 Honda Civic with 26,000 miles on it. It was a long and horrible process to even...
I would have to repaint the car at that rate. Touch up paint and maybe touch up clear with 3000 to level. I'll try to post pictures, but I could use suggestions on free places to host pictures.
Allow me to add to this in a slightly different scale. This is purely focused on a Honda Civic we bought used. People discuss polishing to remove swirls and scratches, and I do polish as well.
...
If what I have doesn't work out or it's effects disappear quickly under FK1000p, I'll try something else. I'll be splitting the rear trunk on the Honda and I'll take pictures after each wash.
These are my personal cars and I want to abrade the paint as little and as infrequently as possible, but still have a glossy near swirl free appearance.
Looking for a relatively quick glaze with fillers when I'm not doing a full once a year polish on my personal cars (Silver Hondas and Grey Metallic Audi). So perhaps once or twice a year (most...
The products, tools and cars I have are below for context. I'm a play it safe first mentality with the paint, but it's not working out on a few situations. Here are my questions:
I used the search function to see some info on taping... really trying to understand when people tape panel gaps, how they don't get to a point where the edges look dull.
I had this issue with the larger backing plate. I didn't lubricate the felt and this happened, got way worse than this. I was also putting quite a bit of pressure and I don't thing it was flat...