Finally decided I needed a new toy. So I picked up a Makita 9227 for a decent price… a couple different backing plates, the meguiars 6” self centering, a cg plate, some other plate that is slipping...
Hmm have you seen a vw r32? The blue pearl paint runs about $600 a quart... and thats factory... custom paint can run you big money... ghost flames... hand painted pin stripes everything is case by...
I use the same, i also picked up the fancy screw on lids for them while i was there work great! and the grit guards fit in the bottom. (clear/white in color) so works great in the aspects of seeing...
Out playing with the camera and the newest wax
collinite 476S
definetly like it.
played with it on the hood... iron x'ed, clayed and then ran menzerna 4500 over it to clean any little swirls out...
Im chiming in late however at this warantee bs for products have you read the disclamer. If you think you paying more is going to keep you covered im sure there companys lawyers will find some flaw...
I know I have read a few guys talking about NOT applying with a DA only because of personal choice.
I remember a few: waste less lost in the pad, and another is the enjoyment of applying the wax.
sorry to steer this off...
maybe im feeding the fire in the wrong direction but FG400/FG500 are compounds... ie not AIO's (although with what i have encountered FG400 comes out Pretty darn good......
newb question since this is an ever learning hobby. what AIO did you use for this? and are there any that you would recomend NOT using on plastic windows?
Your ignorance proves the point of the video even more. A concealed carry permit holder would not have done anything if they knew there rights. They wer not displaying there weapons in a threatening...
as radaryan said, and i should have included in my post. opticoat will not cut down on accumulation; i was trying to get at the fact that they will become much much easier to wash off... with weekly...
I didnt read Everyones post completly so sorry if its a repeat.
Change your pads? Ebc makes good ceramic pads that cut the dust to 20% of what the factory pads were for my golf r.
While chnaging...
Im not going to read this and take offense. 26psi is the minimum pressure required to support the vehicle. I will be inflating to 35psi as per michilins directions directly.
As for the sizing. The...
how to read a tire side wall size:
Sidewall Aspect Ratio
Typically following the three digits identifying the tire's Section Width in millimeters is a two-digit number that identifies the tire's...
the answer i was looking for was 26psi ( not that i will run 26psi...)
the factory kumhos needed 30psi minimum to support the weight of the car... the new michilins only need 26 psi to support the...
So long story short side walll blew out on my wifes kia... ordered 4 new michelin pilot sport a/s3 tires.
Factory tires 215/55-17 pressures front and rear per door pannel is 33psi
Front axle...