Hey Dave, I have been trying to slow down on the aluminum polishing as I am getting tired of being black with aluminum dust/ polish. More and more concentrating on interiors and paint polishing. Your...
Prep of the surface for any sealant is always the most important step. I have used Power Lock many times with great success. I will add to this thread with this link:...
Give PS 21 wheel gel a try, safe for all kinds of wheels. Let it dwell for up to two hours for stubborn dirt. If that doesn't work go for the PS 21 polishing soap, if they are still there then use a...
Depending on where these marks are they could be rock chips but you described clear coat peeling off your bumper and roof. Take this to a reputable paint shop that you trust and have them look at...
I made an adjustable rolling work lamp out of junk material and two t-8 fluorescent lights. Works great at finding swirls and by being adjustable I can go high for doing roofs and low for side...
For anyone that is serious about detailing in a "hot" environment this is the unit that is needed! You got it all in a very well setup stand alone system. There is got to be a buyer out there, they...
Keep reading and by the end of the month you will be able to do this yourself. Take the cash you were going to spend and pump it into the proper tools. Coatings are all in the prep work as others...
I use two Werner platforms side by side. This seems to be enough length so you can finish one whole side without getting up and down to move the platform along. Then move the platforms to the other...
Here are a couple of photos of a Chevy Eqiunox that I coated with Blackfire Crystal Seal roughly 1 year ago. Did the prep work and two coats of product allowing curing in my shop before the next was...
I get a month or so depending on weather conditions. Apply it very thin or it does streak. Good for a spray wax, quick and easy to apply and gives a good shine but no five months that I have seen.
I just put the 3 inch backing plate on and run the unit on a lower speed number. Works good and not a had an issue. As you, i seen no reason to spend extra money on two DA's.
Since I have tried FG400 there is no going back to M105 unless it is to do a relatives vehicle that I am doing for free so I can use up the bottle. Even when using it with wool there is just simply...
I rinse first from the top down to keep lots of water flow and the dirt somewhat suspended. After the inital rinse the one side is pretty much dry and i foam on e side at a time. I use ONRWW in my...
Want to remember this thread so yes i am SUBSCRIBED!! Great teating to say the least. Was on the fence about Wolfgang 3.0 or Powerlock but now i have no reservations about going with the Powerlock!!...
I have the Super Inox and I can't say enough good things about it. This unit is the cadillac of steamers being able to steam, inject chemical and extract all in one unit. The steamer is awesome for...
Mike, yes it is a great unit. The only problem I do have with it is the handle on the vacuum/ steam injection hose is a bit big. There has been times that I just remove thefront seats so I can use...
I use 303, just spray it on diluted a bit from a automotive paint sprayer with a primer tip on it and leave it overnight. Come back the next morning and there is very little to no product to clean...