It's going to be hard to get a brown car to "pop" when reflecting a brown surface (the ground). Maybe you could get a picture where what's reflected is better illuminated and not the same color as...
I used to use it undiluted by squeezing it out of a squeeze bottle on to a wood staining pad, but found it a little too thick to spread easily and evenly. Now I dilute it 1:1 and spray it out of a...
That's what I normally do, but this nozzle must've had a defective shutoff mechanism, because immediately after it triggered, about an ounce or so of gas flooded the area and dripped down the side of...
I tried UIGP for the first time last weekend instead of my usual OPP. I wiped down the interior with a damp MF before applying, it seemed to do a good enough job of removing the old layer of...
Is the Mother's cleaner much more effective on tires than an APC? I've had no trouble getting my wheels clean with OPC with agitation, but anything that would help get the brown off of tires without...
Sounds good, I'll give them a try. How do you find their durability? The Lowes sponges start leaving little bits of sponge on my car after 10 to 20 uses.
I'm a little surprised by this since the gallon container of Aquawax I have doesn't mention UV protection at all. It's one of the reasons I switched to OCW. Knowing this, I'd still choose OCW over...
I went out to my car this morning to drive to work and found a ton of neon green splatter all over the side of my car. Apparently, someone decided to throw a container of neon green fluid at my car...
I haven't had a chance to try them yet, but these drying mats seem to hold a ton of water. I washed them and put them through a full drying cycle and they still came out damp.
I never really understood why it was so important that a car could be dried with a single towel. Is there something wrong with wringing out a drying towel?
I went to Walmart today and grabbed a couple of the towels. I haven't tried using them yet, but at worst, I could just use them as dish drying mats as it says on the packaging. :)
Thanks for the reply. I'm not sure how they were stained, they were there when I bought the car used. Some of it looks like brake dust that won't come off, some of it is light brown (and was...
I have some stains on my factory wheels that wouldn't come off with APC, so I decided to hit it with Poliseal by hand and the stains started coming off slowly. I tried some Ultimate Compound it and...