I wish I had manual drive vehicles. I grew up driving them, and almost always had one. When I got my 1st automatic I was instantly bored with it, and found out really fast they were not as fun LOL!...
I'm thinking that is what he does as well. I kinda do the same thing, clean one up, and drive the other. I'm sure my wife would give me the stink eye if I told her not to drive it! That would make...
This thread sounds like my wife and I with me being the car guy. She appreciates driving her "clean" vehicle, which can be either of the 2 we currently have. But she also thinks I spend too much...
Quick question for you. I was wanting to try out Wolfgang to correct a used car I'm getting that needs some serious love. Which one did you get to remove scratches and swirls? I see they have the...
Ya, that's actually how I do it. I have 2 vehicles that have a low and curvy front end spoiler, areas around the hoods, trunks, and then of course my vinyl on one to work around. It's no big deal...
I got to thinking about how I did it, and I waited an hour, actually a little over, and then applied the second coat. Not sure why I said I waited 24 hours for the second coat.
From what I had read it didn't matter when it was applied as long as it was after the 24 cure period of the last application. I don't know maybe I did it wrong. There were so many different answers...
Very true, I remember even in the 90's the info wasn't readily available, or maybe it was and I didn't try very hard. I do remember trying every single product out trying to get that wet...
I could have easily fit in the 15 years of doing the wrong thing category. Only in the last 10 years have I been making strides in relearning and bettering my technique as time goes on.
I do the same with with a microfiber to get in the areas I can't get into with the polisher. So for now, I'll continue using what I have till I upgrade the Porter.
...
Are these pads universal with all polishers assuming you get the backing plate? I would like to get some for my PC, mainly for the crazy curves I've got in places. Also thinking it would work good...
So I am done with it, except for a second coat of the sealant tomorrow. It went well, although because I didn't have tape or 1" pads, I had to be careful around the graphics.
Hope this is the right are to post this. Also did a search before hand, and there was one thread covering vinyl, but it didn't address what I am asking here.
I would have to say C.Quart UK 3.0 is at the top of my list. Spent a full day prepping the paint so I could apply it. Spent 2 days on applying it because there is a wait period in between coatings....
Ignore most of this, I just went ahead and got one of everything, it's not like they are very expensive. So I'm good to go for anything that I do now. [emoji41]