-
Newbie Member
Re: Best combination with Sonax perfect finish - help
Thanks Mike I would do a test spot but my speculation is as a beginner
what happens if I mess up on the test spot
Once I achieved the result on the test spot will that merge in as i do the whole car
Thanks
Manil
-
Newbie Member
Re: Best combination with Sonax perfect finish - help
WRPT That is hard question to answer as a beginner enthusiast.
Let be put it this way for better understanding I would want to go the little harder way but remove all defects and bring back the gloss.
I am not too sure will that require more aggressive compounds polishers or pads such as the MF and wool pads which as seen in most you tube videos and to be honest it was more technical and confusing.
Appreciate your advice which is appropriate as a beginner to lay hands on then climb the ladder of perfection.
Thanks
Manil
-
Newbie Member
-
Post Thanks / Like - 0 Thanks, 4 Likes, 0 Dislikes
-
Re: Best combination with Sonax perfect finish - help
Looks great! Nice work!
The dusting can be used to much of polish on the pads or working the polish to long or use the pads to long so they gets saturated with polish or no cleaning of the residue on the pads between reload of polish or you have a lot of dead paint to polishing off or the temps and humidity is on the high. Some reasons on there own that could cause dusting or a mix of them. So it's hard to pin point why it's dusting without knowing more of the method you polishing with. And a to high of speed on the polisher can dry out the polish faster too. But PF is not a total free from dusting so with just a little over the hill on the points above and you can see it dusting. But if it was not a lot of dust then don't worrie about it.
/ Tony
-
Newbie Member
Re: Best combination with Sonax perfect finish - help
Thank you @swetm
Speed of the machine was at 4.5 all through the work. I checked the bottle the manufactured date was 2016. I used 3 pea drops only
Not sure why that happened . Will keep your points when I take the next project
Sent from my iPhone using AGOnline
-
Post Thanks / Like - 0 Thanks, 1 Likes, 0 Dislikes
-
Re: Best combination with Sonax perfect finish - help
Originally Posted by
Manilruben
Thank you @swetm
Speed of the machine was at 4.5 all through the work. I checked the bottle the manufactured date was 2016. I used 3 pea drops only
Not sure why that happened . Will keep your points when I take the next project
Sent from my iPhone using AGOnline
Did you clean the pad after every pass?
Car looks good, but you need to use a proper hand held light or the sun to see the true finish.
-
Newbie Member
Re: Best combination with Sonax perfect finish - help
No I did not clean after every pass but after completing half of each panel.
I checked using Rupes LL 150 swirl finder torch.
I did not see any imperfections however not very clear how to spot Haze
Sent from my iPhone using AGOnline
Bookmarks