During the weekend I used XMT2 on my lazer red Mustang. The car had a ton of swirls on the hood and I was looking to get rid of them. Worked the hood in 4 parts, 4 small blobs on the pad each section. Worked it until I THOUGHT that it had broken down based upon it turning clear. Used speed 5 and then ran across the panel with less pressure on 6 to finish.
My question is this. How much swirling should XMT2 get out? I noticed about 70% or so gone now. Is this normal? I may have used a little too much product at the start, would this affect it breaking down?
Thanks
Bookmarks