Post Your Unpacking Pictures

[SNP209]

Does anyone know what psi or GPM the typical coin op produces? Can this 1 do equivalent to the coin op? If so I might get 1 and a new Flexzilla hose and a nice stubby gun. I haven’t even thought about foam but I guess that’s an added +

The coin op pressure is actually pretty low since joe blow down the street might have the nozzle point blank on the paint trying to remove dried on bird droppings from months ago, it's a liability thing. The ryobi unit you have pictured won't have a problem with lacking psi.

If you really want to be el cheapo you can shop around and get a decent hose/nozzle/foam cannon for around another $100-$150 and have a solid setup for $250.

[Coatingsarecrack]

While you would sacrifice some pressure, which wouldn't be a bad thing as the 2300psi is up there for car washing, you could probably open up the nozzle orifice to ramp up the flow rate.

Yeah already did that with an MTM acqualine nozzle gaurd. Got a couple generics off of Amazon that seem nice as well with verying degrees. With proper distance it’s been fine




Sent from my iPhone using Tapatalk

[VISITOR]

[DanaDetailingPros]

Does anyone know what psi or GPM the typical coin op produces? Can this 1 do equivalent to the coin op? If so I might get 1 and a new Flexzilla hose and a nice stubby gun. I haven’t even thought about foam but I guess that’s an added +

With the 2.5 40 degree it gets 1100 psi. I loved mine and hold onto it as a spare.

[VISITOR]

ordered and received (from AE) two car door/trunk support rods for just under $6 for the pair. will come in handy when polishing and doing edge work...




i was gonna buy one of these below but wasn't sure when you tighten the knob to adjust the length, if it could slip/slide and potentially cause damage. don't know how secure it is...

[MisterSnoop]

ordered and received (from AE) two car door/trunk support rods for just under $6 for the pair. will come in handy when polishing and doing edge work...

i was gonna buy one of these below but wasn't sure when you tighten the knob to adjust the length, if it could slip/slide and potentially cause damage. don't know how secure it is...

didn't know they made such things. are the trunk rods intended to be used when you have to drive with the hatch open?

[VISITOR]

didn't know they made such things. are the trunk rods intended to be used when you have to drive with the hatch open?

there suppose to be used for PDR/body work, etc. (machine polishing for many as well). i wouldn't use them while driving though, not to say that you couldn't...

[Big Dave]

didn't know they made such things. are the trunk rods intended to be used when you have to drive with the hatch open?

I've been thinking about asking my nephew to 3D print one of these for me, so I can drive with my back window open in summer, but I'm not sure if fumes and dust would be sucked in. The dogs would probably enjoy it though.

Sent from my motorola edge 20 fusion using Tapatalk

[Big Dave]

I've been thinking about asking my nephew to 3D print one of these for me, so I can drive with my back window open in summer, but I'm not sure if fumes and dust would be sucked in. The dogs would probably enjoy it though.

Sent from my motorola edge 20 fusion using Tapatalk

Sent my nephew the picture this afternoon, 2 hours later here it is, even comes with storage brackets.

Sent from my motorola edge 20 fusion using Tapatalk

[bill walsh]

My boy Bart