Applying Blackfire wet diamond

**Eldorado2k** · 04-08-2016, 09:49 AM

Originally Posted by ronkh57

If dust settles on it, it could cause marring as you remove the excess sealant.

This👆🏽

**07gtcs** · 04-08-2016, 02:58 PM

It is SOOOO easy to put on take off, you won't lose much sleep by wiping off right after you apply it.

**custmsprty** · 04-08-2016, 03:03 PM

Directions:

For best results clay the paint first with BLACKFIRE Poly Clay and polish with BLACKFIRE Gloss Enhancing Polish or BLACKFIRE SRC Finishing Polish.

Hand Application: Always use on a cool surface out of direct sunlight. Apply a quarter size amount of product on a dry applicator pad and wipe on the surface using small, circular motions. Allow Wet Diamond All Finish Paint Protection to dry before buffing. Buff haze with a clean Cobra microfiber towel.

Machine Application: Apply BLACKFIRE Wet Diamond All Finish Paint Protection using a finishing pad or wax pad on an orbital polisher, such as the FLEX XC 3401 VRG Orbital Polisher. Work on a small area, about 24 to 24 inches square, out of direct sunlight. Apply two 6 to 8 inch lines of All Finish Paint Protection directly onto the surface. With the machine off, spread the sealant over the surface using the dry foam pad. This coats the foam pad and the paint with sealant. Place the pad on the paint and turn the machine on. Set the speed dial on the polisher between 3 and 4. Work the pad over the surface in a back-and-forth motion and then an up-and-down motion. Apply until the sealant starts to dry. Cover one section of the vehicle at a time (i.e. the hood, a door, fender, etc.) Allow a haze to form. Hand buff to a brilliant shine with a Cobra Microfiber Towel.