Removing Opti Gloss Coat for spring detail

[spagett]

I applied OGC last spring and strongly believe I applied too little on several sections. This spring I will redo the entire process but want to know if I need to concentrate on removing the remaining OGC FIRST (polishing) or go about the full detail in the normal order (wash - decontaminate - polish, etc.). Regardless, will the panels that still have OGC on them require any more polishing than normal, ie polish once to remove coating, then again to remove defects? Or would you suggest just approaching the whole process as one normally would?

Thanks guys!

[RaskyR1]

I applied OGC last spring and strongly believe I applied too little on several sections. This spring I will redo the entire process but want to know if I need to concentrate on removing the remaining OGC FIRST (polishing) or go about the full detail in the normal order (wash - decontaminate - polish, etc.). Regardless, will the panels that still have OGC on them require any more polishing than normal, ie polish once to remove coating, then again to remove defects? Or would you suggest just approaching the whole process as one normally would?

Thanks guys!

Clay/decon if needed but then just hit it with Hyper Polish and call it a day. Follow with an ONR wipe down or better yet the new Opt Prep.