CG V36 not cutting it

**runrun411** · 09-24-2013, 08:48 AM

This is my new (to me) DD. A 2009 Honda Accord with dark grey paint.

The paint is in pretty good condition with some relatively minor scratches. I've been working on it during my lunch time by claying one panel each day and now I'm ready to start correction.

The paint had a lot of contamination. This is after claying just half of the hood.

I started using CG V36 not thinking I would need to compound since it is a cutting polish. It seems as if it's not cutting enough after 5 or 6 passes with the PC using an orange CG 5" pad. The scratches are barely visible but I see them (only when you really look for them in the direct sun) and it's bothering me.

So turning to my panel of expert let me ask. Honda clearcoat, is it hard or soft? If I need to compound I'll likely use either M101 or FG 400.

**cmoneyinc** · 09-25-2013, 09:22 PM

I had the same problem with V36. Go with the FG400 like I did. You will never look back.

**BradsDetailing** · 09-25-2013, 09:27 PM

Honda paint is probably the softest there is

**TundraPower** · 09-25-2013, 09:51 PM

Originally Posted by cmoneyinc

I had the same problem with V36. Go with the FG400 like I did. You will never look back.

I like certain CG products...their polishes aren't one of them.

**wompasaurus** · 09-25-2013, 09:59 PM

I've never had a problem with v36 if i had to compare it to another well known polish it is right there with m205 but more like in between m205 and meguiars ultimate polish.

**BlackHawk** · 09-25-2013, 10:19 PM

V36 is not a cutting compound, so saying things like oh just use this and that because chemical guys isnt good enough blah blah blah isnt right. Learn the purpose of the product before you go on giving it a bad rep. I find V36 to be a great POLISH not a heavy defect remover. Its great on soft paints.

Seems to me like OP though V36 was enough for his car, but obviously its not. IMO id go with M101. Its better than fg400 from what i have seen. Not all Honda paint is soft...

**Sleypr** · 09-25-2013, 10:21 PM

V34 would have been a better choice, better cut and the same finish.

**BlackHawk** · 09-25-2013, 10:23 PM

Originally Posted by Sleypr

V34 would have been a better choice, better cut and the same finish.

couldnt agree more.

**BradsDetailing** · 09-25-2013, 11:18 PM

Honda accord's have the same softness as civics

**Dogfather** · 09-25-2013, 11:40 PM

Originally Posted by BlackHawk

V36 is not a cutting compound, so saying things like oh just use this and that because chemical guys isnt good enough blah blah blah isnt right. Learn the purpose of the product before you go on giving it a bad rep. I find V36 to be a great POLISH not a heavy defect remover. Its great on soft paints.

Seems to me like OP though V36 was enough for his car, but obviously its not. IMO id go with M101. Its better than fg400 from what i have seen. Not all Honda paint is soft...

The OP didn't say it was a cutting compound. He said cutting polish just as the CG website says. He also didn't say there were heavy defects. Despite this, the CG site says V36 removes moderate to heavy paint defects. I don't feel the OP set his expectations too high at all. Pairing CG's product description with his light defecfts and his allegedly soft paint seems perfectly reasonable.