Ceramic coat after Meguires D166 Ultra Polishing Wax?

[Mikem3574]

Some before.

Sent from my SM-G970U using Tapatalk

[Jayfro]

Very nice work!!!

Jay


Sent from my iPhone using AGOnline

[acuRAS82]

Here are some after pics.

Looks great! You figured out what the paint wanted. Good job!

[amalik]

Update....so after 30 hrs of investigation lol, a decent chunk of change, and a good learning experience, i finally got the truck looking up to par. After swapping out CG products to meguiars (brown and yellow thin foam and D166 i found that I was still getting swirls and holograms. After an initial coat of d166 with brown cut pad (and stupidly wiping it off with an IPA i decided to go at it with another coat od d166 but with yellow pad and slowing my speed down from 6 to 4 and increasing up my arm speed significantly, the swirls and trails are adios. I still have some minor scratches barely noticeable but im willing to live with them. I think a rotary might be needed (oprated bh a pro lol) to get em. Appreciate very much the advice from Mike and everyone. Kick ass to have yhis site available. I will absolutely make sure that any online products i buy go through this site. Takes a village. Thc. (Ima try to post some picschere)

30 hours?

Corona lockdown is treating you well.


Sent from my iPhone using Tapatalk

[Mikem3574]

30 hours?

Corona lockdown is treating you well.


Sent from my iPhone using Tapatalk

Yea....2 full details. I messed up the first 2 step plus ceramic coat with CG. Had to de-grease and re-clay. Then my cut with d166 left trails...so that turned into a 2 step after polish with d166. Restored all vinyl and plastic trim. Interior detail 2x. Chalk it up to a good learning experience.

Sent from my SM-G970U using Tapatalk