-
Carpro CQuartz UK 3.0 and Gliss version 2
I just applied 1 layer of UK 3.0 and found a high spot. Should I polish off reapply to spot? Should I add a second layer of 3.0?
I have yet to apply gliss.
Sent from my SM-N950U using Autogeekonline mobile app
-
Super Moderator
Re: Carpro CQuartz UK 3.0 and Gliss version 2
I would lightly polish and reapply the coating on that panel.
-
Post Thanks / Like - 1 Thanks, 2 Likes, 0 Dislikes
-
Super Member
Re: Carpro CQuartz UK 3.0 and Gliss version 2
Originally Posted by
Bobby B.
I would lightly polish and reapply the coating on that panel.
-
Post Thanks / Like - 0 Thanks, 1 Likes, 0 Dislikes
-
Super Member
Re: Carpro CQuartz UK 3.0 and Gliss version 2
Yea it polishes off real easy. Look good though
-
Post Thanks / Like - 1 Thanks, 1 Likes, 0 Dislikes
-
Super Member
Re: Carpro CQuartz UK 3.0 and Gliss version 2
Yes polish off whole panel, re apply. I tried topping and redoing a section and none of that work.
Sent from my iPhone using Tapatalk
-
Post Thanks / Like - 1 Thanks, 0 Likes, 0 Dislikes
-
Super Member
Re: Carpro CQuartz UK 3.0 and Gliss version 2
For whatever chemical reasons, CQuartz UK, UK3.0, Classic and TI02 will not blend well on spot repairs. Un-like its bigger brothers, CQuartz Pro and Finest Reserve. They both blend in very well on repair work.
-
Re: Carpro CQuartz UK 3.0 and Gliss version 2
i found cquartz classic to darken areas it was applied to so if you went a little over a panel into the next, it would darken that to where you would then have to coat that panel or it will stand out. also seemed like gliss did the same so if you are running out of material probably best to tape off near adjacent panel or something.
Bookmarks