Klasse over ceramic or glass coating

[Mgavin1985]

Hello I’m new can someone answer with experience I have a glass coating on I wanted to test Klasse sealant over the top what would acrylic sealant do to resin glass type coating or even ceramic. Experts chime in I want to test half a good

[The Guz]

Nothing other than change the hydrophobic properties to that of klasse.

[Mgavin1985]

Thanks for answer. Have you ever used permanon as topper or tacsystem moonlight. They both are very interesting to me and seem like a more long term and more durable than the standard reload, c2v3 and cure toppers. Has anyone used these

[MattPersman]

Permanon was old news. Didn’t last terribly long. Similar to hydro2 or wet coat. Ease of use is the key to those

Moonlight has a little bit on it out there. Mostly info on autopia the sister site.

Would run your coating bare or Gyeon can coat over it if you must top


Sent from my iPhone using Tapatalk

[Klasse Act]

I have used Moonlight as a topper on my cars ceramic paint coating and it's great! It's easy to use, thin is really in here and follow the directions about buff time. The finish it leaves behind is very glossy and beads like crazy. One thing about Moonlight is this, sprayer clogs so you might wanna have a spare sprayer handy, even if it doesn't quite screw down on the bottle.

Sent from my SM-G950U using Tapatalk

[HUMP DIESEL]

I have topped CQuartz UK with Klasse and it gives it a really slick feel. For a little cheaper alternative, you can top it the Sonus Acrylic Spritz, which was based off the mixing of the Klasse with water. That can be used as a final wipe down after washing and it will also leave a really slick feeling surface.

HUMP

[Mgavin1985]

thanks for replying I prob going to do a test section I’m i trested In the out com I might try duragloss 111 because they seem to evaporate some thing I have laying around

[Klasse Act]

DG #111 is a great product, pure sealant and easy to use. Apply a thin layer to the entire car and then remove...easy!

Sent from my SM-G950U using Tapatalk

[Mgavin1985]

111 is my favorite and I like it much more than 105. The way I’m thinking about ceramic and glass coating is that reload, cure and c2v3 are basically sealant we are using to put on top of coat they may contain Silica but they are related more to a Sealant than to a coating so why not try a a full strength sealant even if it replaced the surface look and tension that ok I want to avoid water spots on my coating. The only trade of is it may not stay as clean compared to the coating left alone by itself.

[Mgavin1985]

That why I thought Klasse it stays cleanest for me Sealant wise but does more of a sheeting effect and won’t bead as well as other sealant. Plus I’m getting antsy no touching the surface and only doing washings