Car has been corrected too many times what products do you recommend

**estcstm3** · 04-10-2018, 12:22 PM

Hi All,

I have a paint gauge and the paint is all reading around 80um so i do not want to do risk clear coat failure by correcting the paint. What specific products do you all recommend that will help fill the marring/wash induced swirls? And will last more than a wash or two? If its a glaze ideally it can be topped by a sealant Duragloss TPP, WG3.0 without affecting durability.

Also what are your typically paint thickness readings for the cars you are correcting, what numbers give you pause?

Thanks!

**Route246** · 04-10-2018, 12:34 PM

+Following this thread. I have a friend with a car in the same state.

**WillSports3** · 04-10-2018, 01:05 PM

How many times has that paint been polished to get that low?

**MarkD51** · 04-10-2018, 01:08 PM

IMO, and if it's my choice.
And just like I did on my own beloved 1997 Tahoe in my Avatar with only 45K on the Odo, which as you know is now 21 years of age, I decided to go with a Quartz Paint Coating about 3 years ago.

The Coating I personally chose, was Carpro CQuartz UK.

In reality, it didn't seem to much matter that I have tried my hardest to meticulously maintain the finish over the years, and with the use of high quality products such as Collinite Waxes, Megs #20 Sealant, Zaino, and others, I felt that as they say "Time waits for no Man", and that as well father time will eventually take its toll on a pant finish with UV damage, oxidation, continual washing, other contaminants, road salts, rains, on and on.

Only way to stop such aging and wear, place the vehicle in a glass case.

That my personal thoughts were that such paints aren't going to take a continual pounding with the washes, with the cleaner waxes, with polishing, that eventually something has to give, and that give in my case, and probably yours as well will be clear coat failure.

IMO, there's nothing out there at present as far as conventional waxes or sealants go, that will protect as well as a very good paint coating will.

That they are much more durable against washing induced marring, chemical and fallout attack, UV damage, etc. They will then become the sacrificial top and outermost coating layer upon the paint.

Such is not really open for debate IMO, as it is known fact coatings are much more durable and can offer a good number of benefits to a paint system, especially one that has seen better years.

I myself am a hobbyist, but on occasion have detailed other's vehicles not only over years, but many decades (I'm 63), but for my own personal vehicles, I feel a paint coating has become a no-brainer, and will be what I'll reach for.

That any future vehicle(s) I may ever acquire in the future, it will definitely be coated after decon and correction if needed. Same with all trim and wheels.

Hope this helps.

**JCDetails** · 04-10-2018, 01:10 PM

At 80 microns I wouldn’t even be thinking about abrasive polish of any kind.

Anything under 120 I start to get real cautious and take additional readings especially near edges.

You need an acrylic glaze of some kind so that you can top it with the sealant. Lots of guys like CG easy creme, not sure if blacklight or white light are acrylic, some others are out there. Then top with power lock or your choice of sealant

Sent from my iPhone using Autogeekonline mobile app

**limited0602** · 04-10-2018, 01:19 PM

This sounds like a job for something like CarPro Essence? Then top it with a ceramic coating of your choice and hopefully you'll be safe for a long while.

**Cruzscarwash** · 04-10-2018, 01:23 PM

Originally Posted by limited0602

This sounds like a job for something like CarPro Essence? Then top it with a ceramic coating of your choice and hopefully you'll be safe for a long while.

What about blackfires new paint cleaner? That is just filler as well right?

Sent from my Pixel using Tapatalk

**DBAILEY** · 04-10-2018, 01:28 PM

Prima Amigo or the CG glazes. Most things sit on top of acrylic glazes with no problem.

**limited0602** · 04-10-2018, 01:32 PM

Originally Posted by Cruzscarwash

What about blackfires new paint cleaner? That is just filler as well right?

Sent from my Pixel using Tapatalk

Not really sure as I've never looked into it. I just remember reading that Essence can do what the OP is requesting, so I bought some myself to use on my Lincoln MKS that is swirl heaven right now.

**Cruzscarwash** · 04-10-2018, 01:36 PM

Originally Posted by limited0602

Not really sure as I've never looked into it. I just remember reading that Essence can do what the OP is requesting, so I bought some myself to use on my Lincoln MKS that is swirl heaven right now.

I thought it had a very light polish in it

Sent from my Pixel using Tapatalk