-
Super Member
-
Super Member
Re: Let's see if Solution Finish will hold up
Top it with Dlux and you will get 6-12 months for sure, providing your prep was good.
-
Post Thanks / Like - 0 Thanks, 1 Likes, 0 Dislikes
-
Super Member
Re: Let's see if Solution Finish will hold up
Prep was a scrub down with APC, water rinse, the sprayed with IPA then applied
-
Super Member
Re: Let's see if Solution Finish will hold up
Looks good.
You can top it with another product like wolfgang exterior trim sealant. Works very well. I have moved back to a trim sealant after hearing Chris West talk about coating plastic trim on a podcast.
-
Post Thanks / Like - 1 Thanks, 0 Likes, 0 Dislikes
-
Super Member
Re: Let's see if Solution Finish will hold up
2014 Ford Mustang GT Track Pack-Black
2015 Chevrolet Silverado Crew Cab 4x4- Summit White
-
Super Member
Re: Let's see if Solution Finish will hold up
Originally Posted by
The Guz
Looks good.
You can top it with another product like wolfgang exterior trim sealant. Works very well. I have moved back to a trim sealant after hearing Chris West talk about coating plastic trim on a podcast.
mike, if you don't mind me asking... what downsides are there about coating plastic trim that chris west mentioned?
-
Super Member
Re: Let's see if Solution Finish will hold up
Originally Posted by
VISITOR
mike, if you don't mind me asking... what downsides are there about coating plastic trim that chris west mentioned?
Chris mentioned that the coating clogs up the pores of the plastic at the microscopic level. Meaning it could "block" solution finish from penetrating into the plastic the next time it's time for another round of solution finish. I believe he mentions that trim sealants don't penetrate into the plastic like SF but sort of sit on top.
I believe it was in this episode where Chris mentions it.
-
Post Thanks / Like - 1 Thanks, 2 Likes, 0 Dislikes
-
Super Member
Re: Let's see if Solution Finish will hold up
Originally Posted by
The Guz
Chris mentioned that the coating clogs up the pores of the plastic at the microscopic level. Meaning it could "block" solution finish from penetrating into the plastic the next time it's time for another round of solution finish. I believe he mentions that trim sealants don't penetrate into the plastic like SF but sort of sit on top.
I believe it was in this episode where Chris mentions it.
looks like at around the 21:48 mark. thanks for the info!
-
Post Thanks / Like - 1 Thanks, 1 Likes, 0 Dislikes
-
Super Member
Re: Let's see if Solution Finish will hold up
Originally Posted by
The Guz
Chris mentioned that the coating clogs up the pores of the plastic at the microscopic level. Meaning it could "block" solution finish from penetrating into the plastic the next time it's time for another round of solution finish. I believe he mentions that trim sealants don't penetrate into the plastic like SF but sort of sit on top.
That makes no sense? If I clean and prep correctly, apply SF correctly and it supposedly penetrates into the plastic then covered with a coating. Shouldn't the coating be the first thing to go away/wear out before another application of SF is needed? Just asking / thinking out loud again.
-
Super Member
Re: Let's see if Solution Finish will hold up
Originally Posted by
kb2ehj
That makes no sense? If I clean and prep correctly, apply SF correctly and it supposedly penetrates into the plastic then covered with a coating. Shouldn't the coating be the first thing to go away/wear out before another application of SF is needed? Just asking / thinking out loud again.
I'm not a plastic expert so I can not answer this. I refer you to the video where Chris West talks about this. Visitor was kind enough to note the minute mark.
Bookmarks