How long does it take you?

[Emt1581]

Prior to my current vehicle, I never had one that I cared enough about to wash it much. And never waxed one. Just would dip scrub brushes in a single bucket with a squirt of turtle wax soap mixed in, scrub the vehicle down and then rinse it off.

Now, using three buckets and two sets of washboarded grit guards...

I spend about 30 minutes foam gunning the tire/wheel one at a time, brushing the wheel, scrubbing the spokes with a mitt, and then rinsing it off. Then another 30-45 min. using the foam gun on each section/side of the body and a mitt, and finally another 45-60min. drying it off with a shop vac and then towels.

...we're not even into the time of waxing, sealing, wheels, plastics, interior, etc.

For doing one car, should it take 2 hours just to wash/dry it or am I doing something wrong? I'm looking at blocking out an entire weekend day just to do the wax, seal, etc. in the near future. Is that what pretty much everyone does or, again, am I going about this wrong??

Thanks

-Emt1581

[PA DETAILER]

I spent 3 hours Saturday evening on 2. My xterra and her Escape. They were normal washes. Foam gun. Wash. Wheels/tires. Dry. Quick interior. Dress tires. Things were ok till I noticed sap bombs on her Escape. Spent some time getting them off!!

[JeffsRealm]

I think it is going to depend on the products you use and how you use them. Once you have a good wax and so on on your car washing is really quick and easy as stuff doesn't stick as well. Same for wheels, as I just posted a question on this. If you spent a couple hours cleaning and then putting on a good sealant on your rims and used a long lasting blackening agent on your tires, well then every time you wash your car you just buzz over your tires quickly with your wash mitt at the end of the wash and tires and rims are clean. You get maybe 4 years of this from spending a couple hours up front doing it this right way.

Here is a link to that thread which has brands and some other links.
https://www.autogeekonline.net/forum...tter-plan.html

Then there are other products like say Pinnacle Souveran Wax which is an awesome wax, it is expensive but one can should last you the lifetime of your car. Also As soon as your done washing you simply wash on and wipe right off, no need to let dry. Very easy to work with you only need to apply every couple months.

Then like me this weekend I did a full out detail with clay bar, polish and then 2 coats paint sealant. Roughly spent 8 hours, but I don't have to go through that again for a long time.

[LEDetailing]

You are being meticulous, speed up and you might miss something. I try not to look at my watch when washing. Just give yourself enough time and don't sweat it.

To save time when I'm short on time and it's just a light dirt on my cars. I use this method. Initially skip your wheels, tires, and wheel wheels. When done washing and rinsing, dump your 2BM soap water into your wheel bucket and do a quick wipe down of the wheel face with a mitt and tire brush with soap on tires. If using free flowing water you can even dry your entire car and save the wheel faces and tires for last.

I used this method last night on my van. Just removed bugs and light dust/dirt. I skipped the wheel wells. They still looked good.

[PouncingPanzer]

It used to take me 2 hours, I'm down to 1:15-1-:30 or so. So, you're not too far off.

As mentioned, this is a meticulous wash, which on my car is all I can bring myself to ever do. But, that's my perfectionist mentality haunting me, again. There is spotless, or filthy, nothing in between in my eyes.

Now, at the detail shop, you won't make a dime taking that long. So, the process, tools, and amount of hands involved is rearranged. It takes 40-50 minutes at the shop with my friend and I. 38 minutes is our best but in the defense of being meticulous, there were multiple spots missed and I had to grab a QD and go back over them.

Products play a roll, but technique plays a far greater one and over time you will lean-out your process and shave off a few minutes here and there. Then once you get your process pinned, you'll get a new car with new features and places to clean and start alllllll over again. Well, not allll-over, but some.

Good luck!

[Emt1581]

You are being meticulous, speed up and you might miss something. I try not to look at my watch when washing. Just give yourself enough time and don't sweat it.

To save time when I'm short on time and it's just a light dirt on my cars. I use this method. Initially skip your wheels, tires, and wheel wheels. When done washing and rinsing, dump your 2BM soap water into your wheel bucket and do a quick wipe down of the wheel face with a mitt and tire brush with soap on tires. If using free flowing water you can even dry your entire car and save the wheel faces and tires for last.

I used this method last night on my van. Just removed bugs and light dust/dirt. I skipped the wheel wells. They still looked good.

Thanks for the tips!

My problem is that my car is around 4 months old now and I've only applied wax once. Other than that I've washed it every 1-2 weeks.

So I've got clay, wax, seal, tire dressing, plastics, etc....all due. I figure I'll block out a Sunday (my only full day off) at my station. Close the bay door and get cracking early in the morning. Hopefully I'll make it to dinner. But I'm thinking that'll be the most attention I'll have to give the cleaning process in one shot for at least 6 months or so. Plus, as replies mentioned...doing the more time-consuming steps means reducing the time it'll take to wash/dry on a regular basis until those applications are needed again.

EDIT: As far as short changing the wheels...not sure if that'll work for me. I have a TON of brake dust and the water running off the wheels onto the floor is a shiny copper/black color...looks like tar! So skimping on that might not be the best for the paint/rotors. However, after a wheel dressing, hopefully I'll be able to take a couple shortcuts.

Thanks!

-Emt1581

[FUNX650]

•This might not provide
much, if any, solace...but:

-So far (for year 2017), I've been
a-washing on our vehicles' panels,
wheels, glass, etc. since April...
and, I'm still not all the way done
with any of them!

-Yet...Am I all awash with guilt
for that shortcoming? Hardly...


Bob

[TTQ B4U]

Prior to my current vehicle, I never had one that I cared enough about to wash it much. And never waxed one. Just would dip scrub brushes in a single bucket with a squirt of turtle wax soap mixed in, scrub the vehicle down and then rinse it off.

Now, using three buckets and two sets of washboarded grit guards...

I spend about 30 minutes foam gunning the tire/wheel one at a time, brushing the wheel, scrubbing the spokes with a mitt, and then rinsing it off. Then another 30-45 min. using the foam gun on each section/side of the body and a mitt, and finally another 45-60min. drying it off with a shop vac and then towels.

...we're not even into the time of waxing, sealing, wheels, plastics, interior, etc.

For doing one car, should it take 2 hours just to wash/dry it or am I doing something wrong? I'm looking at blocking out an entire weekend day just to do the wax, seal, etc. in the near future. Is that what pretty much everyone does or, again, am I going about this wrong??

On my personal vehicles I have it down to about 1hr to 1:15. Unless a buddy/neighbor comes over to chat then it can go on for hours

[derass]

It used to take about 2 hours for me to do a good wash as well. But I've shortened that down by washing bigger sections before rinsing.

30 minutes per wheel does seem too long though. Maybe takes me 5-10 each. That's rinse, spray with wheel cleaner, wash face with mitt, wash barrel with Wheel Woolie, scrub the tire and then final rinse.

Also 45-60 minutes for drying does seem long. But I don't use any sort of blower. I just "flood" the paint, hit a section with waterless wash as a drying aid, then run my PFM towel over it. Maybe 20 min for the entire car.

[Kamakaz1961]

For a simple wash and dry, I am looking at around 45 Minutes to an hour. Rinseless wash is around the same. If I am going to do a wash and wax I would look around 2 to 3 hours. The good thing is I have fun even if these are just guesses in the time thing.