Help - Urgent question with P21s Carnuba

**tampatopless** · 05-21-2017, 01:12 PM

Ordered some P21s Carnuba on here last week and was going to use it today. However, when I went to open the can, it opened really easy - like it had been opened before. The sticky paper was on top of the wax, but when I peeled it off, the wax underneath was rock hard. Like hardened wax or what paste wax looks like after a while if you don't put the top back on it.

Is it supposed to come like this from the factory? Is that that hard? I literally have to scrape it loose with a fingernail to get any on the sponge.

Any help is appreciated.

**Paul A.** · 05-21-2017, 01:43 PM

I might suggest warming it up a bit in the sun. I haven't used that wax in years but i do remember it being somewhat hard in the can. It's probably fine. Just apply it thin.

**tampatopless** · 05-21-2017, 01:48 PM

OMG. Just figured it out. And it's amazing. You take the sponge, rub in a clockwise - or counterclockwise - motion in the tub. The friction generates enough heat to get a nice coating on the sponge. And it really does go on like butter. It is the easiest LSP in terms of application that I've used. And I've used Zaino, NXT, Wolfgang DGPS, etc.

I did a Mustang Vert in about 15 min. Curious to see the end result.

**Riff** · 05-21-2017, 04:38 PM

I've been using P21S 100% Carnauba for a couple years now and yes, it is rock hard.

You only need to apply it super thin so just lightly rubbing the applicator on the wax by twisting it back and forth a couple times puts enough product to do most of a panel.

It gives an amazing shine and is very easy to wipe off. I love it.

Sent from my iPhone using AGOnline