Help: Lots of scratch after compounding and polishing

[Damsonlee]

I compounded and polished my car this weekend. But I just found it created lots of deep scratches. It looks terrible under sunshine. I cleaned the car by washing and clay bar cleaning. I used Maguair's DA polisher and powerpads. I appreciate any suggestions on how to remove the scratches.

[GSKR]

That's paint checking needs repaint.

[Legacykid]

Those werent there prior?

Did something get inbetween your pad and paint to have scratched it?

Whats your experience detailing?

[GSKR]

They were there you just filled them in with compound.

[Damsonlee]

I noticed there were some scratches before I started compounding. But I didn't see that many scratches. There might be something get onto the pad as I just used one pad for the whole car and did not clean it during the process. I still can't believe it would cause so many scratches even if I got some dirt onto the pad. Only the engine hood is bad. The doors and other parts of the car look ok. If there is dirt on the pad, I would have damaged the doors and other parts as well. I don't have much experience in detailing but just followed some online instructions. The compound and finish I used are Maguair's Ultimate compound and polish.

[Damsonlee]

They were there you just filled them in with compound.

I also think there were there but the compounding and polishing made it worse. But my wife doesn't believe it. Now is it possible to remove all these scratches without repainting?

[dlc95]

Kind of looks like crows feet. The only solution as GSKR mentioned, is a repaint.

[DaveT435]

I also think they were there, just the white compound in them makes the much more noticeable.
The only crows feet I've seen were on a black Acura. They really didn't look like that. What kind of car is it?

And again, not doubting anyone or saying your wrong. GSKR I know there have been a couple posts lately where it may seem like I'm saying your wrong...want to make sure you know that isn't the case.

[A2D Signature]

That is why I constantly check my pads and change my pads after 1 or 2 panels

[Eldorado2k]

Just curious, you said you used 1 pad on the entire vehicle.. What kind of pad? Meguiars thin burgundy foam cutting pad? Which panel did you start with? Was the hood 1st, or last? Did you notice your results diminishing at all as you were going along?

I kinda feel bad for you that your wife seems a bit disappointed... For all the chicks who couldn't care less about what their men are doing while detailing. And this woman does during these results.. I feel for you man. Make it up to her another way