-
Looking for a compound that offers slightly more cut than 3D One
What compound would you recommend that offers slightly more cut than 3D One? I want something that I can go to if 3D One and a microfiber cutting pad on a 8mm DA polisher isn't getting the job done. Basically, something for hard clear coat. I'm currently looking at Jescar correcting compound and Sonax CutMax but open to other suggestions. Thank you
-
Super Member
Re: Looking for a compound that offers slightly more cut than 3D One
I use Griot's Fast Correcting Cream but be warned. If you are using a microfiber pad you will have to go behind with a finishing polish.
-
Super Member
Re: Looking for a compound that offers slightly more cut than 3D One
Sent from my SM-G988U using Tapatalk
Ripping through your mind like a hurricane full of novocaine
-
Post Thanks / Like - 0 Thanks, 1 Likes, 0 Dislikes
Brrr liked this post
-
Super Member
Re: Looking for a compound that offers slightly more cut than 3D One
I put a few up against 500 and CARPRO Ultra Cut and The Last Cut+( LAST CUT+ was the strongest)
-
Super Member
Re: Looking for a compound that offers slightly more cut than 3D One
Almost every compound. One isnt really that strong.
"Dirt likes detergent so much better than the surface that it's attached to, it'll leave that surface to go hang out with the soap"...
aim4squirrels
-
Super Member
Re: Looking for a compound that offers slightly more cut than 3D One
3d 510 is my compound of choice. 3d 500 is good as well but never tried with my pads since i dont use those. Never used 3d one.
Back when i first started and used my megs mt300 free spinning da, megs d300 compound with thier mf pad work really well together. Very under rated. Finished down really nicely.
Sent from my SM-S901U using Tapatalk
-
Super Member
Re: Looking for a compound that offers slightly more cut than 3D One
Originally Posted by
dcjredline
Almost every compound. One isnt really that strong.
Exactly
Ripping through your mind like a hurricane full of novocaine
-
Super Member
Re: Looking for a compound that offers slightly more cut than 3D One
Originally Posted by
98CayenneTA
Sent from my SM-G988U using Tapatalk
How would you compare 3D One with this product, cutting and finishing ability wise, thanks.
Flex 3401 & PE14
Bookmarks