Prep - Cutting the PVC to size

  1. 4x
    6-1/4" of the 1" pipe

  2. 4x
    For each of the Snap X Thread Tees, cut off the snap section from the perpendicular threaded section to one end.
    Leave the other side intact.
    Do not use the Slip Tees for this.
    Before (left), After (right):

  3. 2x
    2-1/2" of the 3/4" pipe

  4. 8x
    1-3/4" of the 1" pipe
    Technically this should be 2", but it can be a PITA trying to slip it all the way into the other pieces.

  5. 4x
    4" of the 1-1/4" pipe
    I couldn't get the caps off for the picture.
    Sorry for how that looks...

  6. 4x
    Make a tiny hole in the very top of the cap.
    This is where the drill and the 3/32" bit come in.


After you have cut everything, be sure to clean up any rough edges and flakes of PVC. You probably don't want that getting into your pads.