-
Super Member
Where does everybody stand on priming their pads?
And different types of pads? Microfiber, LC wool, regular foam? A watch a few internet videos and it seems that everybody has a different opinion. I'm curious as to what the general consensus is for different types of pads and/or compounds, polishes, waxes. Thanks in advance.
-
Super Member
Re: Where does everybody stand on priming their pads?
I don't do it in most cases.
-
Super Member
Re: Where does everybody stand on priming their pads?
Originally Posted by
Route246
I don't do it in most cases.
That's Scott from Dallas PC. He says he only does it on microfiber.
-
Super Member
Re: Where does everybody stand on priming their pads?
I definitely prime my Lake Country CCS foam pads for swirl removers and polish. I like to fill in all of the pores of the foam with some product. Is it necessary? I'm not sure but I like the idea of not having dry foam rotate on the paint.
-
Post Thanks / Like - 1 Thanks, 1 Likes, 0 Dislikes
-
Junior Member
Re: Where does everybody stand on priming their pads?
I put a little product on foam pads. Don't like the idea of a completely dry foam pad.
-
Post Thanks / Like - 0 Thanks, 1 Likes, 0 Dislikes
-
Super Member
Re: Where does everybody stand on priming their pads?
I just use a circle of product on foam to start, then 3-4 pea-sized dots after.
I find that the pads gum up a little quicker when primed. Just my opinion.......
It is no coincidence that man's best friend cannot talk.
-
Post Thanks / Like - 0 Thanks, 1 Likes, 0 Dislikes
-
Super Member
Re: Where does everybody stand on priming their pads?
Used to when I started but no longer except for microfiber on occasion.
-
Post Thanks / Like - 0 Thanks, 3 Likes, 0 Dislikes
-
Super Member
Re: Where does everybody stand on priming their pads?
Originally Posted by
PaulMys
I just use a circle of product on foam to start, then 3-4 pea-sized dots after.
I find that the pads gum up a little quicker when primed. Just my opinion.......
That has been my finding as well. To a tee.
-
Post Thanks / Like - 0 Thanks, 1 Likes, 0 Dislikes
-
Super Member
Re: Where does everybody stand on priming their pads?
I don’t personally prime my foam pads. I will prime my microfiber pads though.
I’ll keep a QD nearby to give the pad one spray before I apply product for the first time.
In the start it’s 4 pea sized drops, then 3 moving forward. I’ve never used a circle around the pad, but I suppose I could try that sometime.
Sent from my iPhone using Tapatalk
-
Super Member
Re: Where does everybody stand on priming their pads?
Originally Posted by
Chopper280
I put a little product on foam pads. Don't like the idea of a completely dry foam pad.
Yes, but the foam and product will quickly interact over the first section pass.
I'm just a DIY guy, but I found out very quickly that too much product = reduced cut, heat build up, and PITA cleaning.
It is no coincidence that man's best friend cannot talk.
-
Post Thanks / Like - 0 Thanks, 5 Likes, 0 Dislikes
Bookmarks