Hard time removing Uber

[DetailKitty]

30 minutes is definitely too long, after I finish the panel I wait about 30 seconds and then take it off. Anything longer than a couple of minutes is going to be very tough to remove as you stated.

Learning curve I guess... next time I'll use it sparingly and only wait a minute or 2 after a section is done.

[SeanChav]

I was looking to get Uber AIO for its great cut and durability for a AIO, but after reading many reviews about the wipe off I ended going with Speed due to ease of use and underrated cutting power

[DetailKitty]

I was looking to get Uber AIO for its great cut and durability for a AIO, but after reading many reviews about the wipe off I ended going with Speed due to ease of use and underrated cutting power

I'm gonna give it another go this weekend. It would be great if I can get it to come off easy.

[SeanChav]

I'm gonna give it another go this weekend. It would be great if I can get it to come off easy.

let us know how it works out, and maybe a picture of the amount of product u use if u find that it's easier with less

[DetailKitty]

let us know how it works out, and maybe a picture of the amount of product u use if u find that it's easier with less

You got it

[bwatereagleman]

I did a write up on the Uber All-In-One which highlights the very issue you are experiencing. Take a look if you wish. You can skip to "My final thoughts" if you want to see how I went about addressing the issue.

Uber All-In-One ... Review and Initial Thoughts

[DetailKitty]

I did a write up on the Uber All-In-One which highlights the very issue you are experiencing. Take a look if you wish. You can skip to "My final thoughts" if you want to see how I went about addressing the issue.

Uber All-In-One ... Review and Initial Thoughts

Thank you! Sounds like you ran into what I did. I'm still going to give it another try.

[GSKR]

It smells and performs just like lite finish from Malco.