Damp-Sanding Advice?

**Lasthope05** · 05-27-2010, 04:23 PM

Thanks for that post Mike and the pics of the new sanding disks by Meguiars. I have no experience with the Megs sanding disks but I do use 3m almost exclusively(thinking about making the switch to Abralon because I found a good bargain on them.) I know the 3m perfect-it III Trizact disk is a very soft foam which is easily compressed. My question to you is, since both are available to you, is the foam structure and density similar between Meg and 3M.

Mike Phillips · 05-27-2010, 04:50 PM

Originally Posted by Lasthope05

I know the 3m perfect-it III Trizact disk is a very soft foam which is easily compressed. My question to you is, since both are available to you, is the foam structure and density similar between Meg and 3M.

They're similar enough that I don't there there would be any appreciable difference but I'll look.

Mary...

I have all the pictures taken and but wont' be able to finish the article till tomorrow...

You can see most of them here...

Wet-Sanding - AutogeekOnline Gallery

**Mary Steinborn** · 05-27-2010, 05:15 PM

Originally Posted by Mike.Phillips@Autogeek

They're similar enough that I don't there there would be any appreciable difference but I'll look.

Mary...

I have all the pictures taken and but wont' be able to finish the article till tomorrow...

You can see most of them here...

Wet-Sanding - AutogeekOnline Gallery

Thanks, Mike, and again, I'm not in a hurry. I look forward to reading the article when it is ready