I have a job coming up for a black explorer. It is covered in water spots. On the estimate I cleaned a small spot with onr QD strength and most of the spots were cleaned but there is still spots. There is also a lot of wash induced scratching. I am wanting to try carpro spotless on it for a good test but also want to polish it to remove scratching. The owner of vehicle has very hard water with lots of sulfur.
My question is this, normally with paint correction I top with 845. Lasts forever and stays clean. But I've not dealt with this hard of water yet. How will 845 do at resisting the hard water spotting/ sulfur? Will the sulfur eat wax off? I also have reload, shoud I top with Reload instead? I'm looking for the best water spot resisting and strength against sulfur without going to a coating.
Bookmarks