4" backing plate??

[DaveT435]

I use this 3.5 BP" with 4" pads. Works fine.

They pad is actually about 5 inches, the Velcro is 4 inches and they're really thick. They won't work on a 3.5.

[DaveT435]

It's not the ideal setup, you need to be careful not to let a lot of heat build up. You're moving the bad out from the machine. How many of the pads did you buy?? There is a thread on here to trade products. I saw someone trying to trade some 5.5" CCS pads on there the other day. A lot of 3401 users so that might be a good thing to try first.

[wgasa84]

It's not the ideal setup, you need to be careful not to let a lot of heat build up. You're moving the bad out from the machine. How many of the pads did you buy?? There is a thread on here to trade products. I saw someone trying to trade some 5.5" CCS pads on there the other day. A lot of 3401 users so that might be a good thing to try first.

That's the conclusion I'm leaning towards. The 4" rotarty BP + adapter is approx $20... for pads that I may have issues with. Not a good ROI. Probably best to cut my losses and find something that is better suited.


I have 2 finishing pads, 2 polishing pads and 4 light cutting pads. One polishing and one light cutting used for less than 10 minutes.

Sent from my SM-G955U using Tapatalk

[DaveT435]

Here is the thread. You may want to look through the last few days and see if there are any pads you might be able to trade for and go ahead and make that post there and list you want to trade for 5.5" pads

SAMPLES (original post updated)

I know a lot of people really like the light cutting pads. You might want to clean that one up a little, or is that stain?

[wgasa84]

Here is the thread. You may want to look through the last few days and see if there are any pads you might be able to trade for and go ahead and make that post there and list you want to trade for 5.5" pads

SAMPLES (original post updated)

I know a lot of people really like the light cutting pads. You might want to clean that one up a little, or is that stain?

Thank you!

It was used on a single stage. It's just stained, clean, but stained.

Sent from my SM-G955U using Tapatalk

[DaveT435]

Thank you!

It was used on a single stage. It's just stained, clean, but stained.

Sent from my SM-G955U using Tapatalk

I figured that was probably the case. Hope you find a good trade.

[wgasa84]

I figured that was probably the case. Hope you find a good trade.

Thanks for the suggestion! I was able to make a trade.

Sent from my SM-G955U using Tapatalk

[topdawg57]

I picked up some 5" Hybrid Power Finish pads on BOGO and they need a 4" backing plate. I tried my 3" but the pads flex too much on such a small backing plate. Any suggestions for finding a 4" backing plate for a GG6? I have seen a few DA 3 1/2" backing plates, but no DA 4". I might have to do a 4" rotary backing plate with an adapter.

Thanks!

Contact Kevin Brown At Buff Daddy .com I had one custom made for my hybrid pads.

Sent from my SM-G935P using Autogeekonline mobile app

[topdawg57]

Contact Kevin Brown at buff daddy. Com I had one custom made.

Sent from my SM-G935P using Autogeekonline mobile app