flex xfe7-15 specs

[Mike@DedicatedPerfection]

Mike when u have your xfe7-15 out later on ,could u please measure the backing plate ? I would really appreciate it ty

Will do.

[Zubair]

Could you point us to this thread?

Here is information taken directly from FLEX-Tools website.
https://www.flex-tools.com/gb/Produk..._VRG/index.php

I didn't bookmark it but many here have read it, hoping someone can link it, better yet Mike P can post it here. The BP was marked at every orbit, very interesting thread.

[Mike@DedicatedPerfection]

As the FLEX XFE is the original topic of discussion, here are the technical specs on it.
https://www.flex-tools.com/gb/Produk..._150/index.php

[Mike@DedicatedPerfection]

I didn't bookmark it but many here have read it, hoping someone can link it, better yet Mike P can post it here. The BP was marked at every orbit, very interesting thread.

Sounds interesting. Will be on the lookout for it.

[Mike@DedicatedPerfection]

Hi folks I'm researching polishers and I'm seeing conflicting specs on this new polisher regarding max opm's I've seen 8400 9600 and some pics of 5400 on the plate on the tool . Which is correct ?

Have you had a chance to see my unboxing thread? There are plenty pictures about the tool and other FLEX polishers inside.

On top of the machine it displays 3k-9k. On the side shows 1500-4500. I would imagine on top of the machine shows OPM while the side shows RPM.

FLEX XFE7-15 150 Unboxing/FLEX picture comparison

Mike when u have your xfe7-15 out later on ,could u please measure the backing plate ? I would really appreciate it ty

I had a chance to measure the backing plate and it comes out to 5.75" exactly. I am displaying the 6.5" Lake Country Thin Pro pads in the thread.

[postaltwo]

Have you had a chance to see my unboxing thread? There are plenty pictures about the tool and other FLEX polishers inside.

On top of the machine it displays 3k-9k. On the side shows 1500-4500. I would imagine on top of the machine shows OPM while the side shows RPM.

FLEX XFE7-15 150 Unboxing/FLEX picture comparison



I had a chance to measure the backing plate and it comes out to 5.75" exactly. I am displaying the 6.5" Lake Country Thin Pro pads in the thread.

Tyvm Mike . I will check out your thread cheers

[Joe@NextLevelDetail]

Zubair is right, the 3401 is no where near 9400 opms. Its not even close.

5400 opms sounds about right.

It is due to the forced rotation, it can only go so fast.

[postaltwo]

Well I wonder if this new xfe unit is like that too then