I've been using the B&S flat pads too with good luck, but I think I'm going to try out their Low-Pro pads. Thinner pads seem to be favored now. Should run cooler too.
I really prefer using a foam cannon with my vehicles. My pressure washer actually has dual on-board soap tanks with independent On/Off valves so you can use one or both at the same time, or none at...
I use ONRWW on just about every exterior surface of our vehicles and luckily, I have never experienced streaking on glass like you described. I'd give it a try again and see what happens. It might...
Not really a waste but if the top coating you are applying has any kind of solvents in it, then it is more than likely removing the initial protection left behind by the AIO as you apply it.
I've been using Hydro Blue on both of my DD recently. After application of HB, I go until the cars need washing. I then either do a 2B wash or if it's just real light dirt, I'll do a waterless...
Btw, I'm more than a little disappointed that the small 6 oz sized bottles of UQW have now been discontinued at AG.
They were a steal of a deal, so I can't say I am...
Dont forget about Meguiars White or Black Waxes.
I used White Wax with good results recently. It had a fair amount of cut.
But I did end up topping it with Ult. Fast Finish, so I can't comment on...
I'm kinda in the same boat as you..... looking at picking up some of the newer thinner 5.5" pads for my PC, but like you I'm not exactly sure which ones to get either....
Same here. I the very first thing I ever polished with a DA, was my tractor.
I was worried about ruining the paint on my vehicle, so I polished up the tractor real pretty while getting the hang of...
The Tolco Gray (chemical resistant) sprayers with a 9" draw tube is part #110542
The Tolco Gray (chemical resistant) sprayers with a 7" draw tube is part #110544
The Tolco Gold (chemical and acid...