Search:

So I was pretty set on getting the rupes pads to go with the rupes mini I am planning to purchase and then came across pads that seem to be made for the rupes mini by Adam's. Anybody have any...

This and your previous quote regarding tearing up of "other" pads has been very insightful. I'll have to start seriously looking into the whole Rupes line. Thanks Custm! :xyxthumbs:

Sweet, thanks for the tidbit AGO!

Thanks for the tidbit AGOatemywallet, on a side note, what are some techniques to avoid burning through the clear coat when using MF pads on bumpers? I assume you were referring to burning the clear...

That is what I was thinking, thanks for the confirmation Paul! I'll take a look into the yellow flat pad but lately I been thinking of moving over to MF pads for heavy corrections after realizing how...

Hey Paul,

This is the route I been contemplating, I just need to figure out if I want to go Rupes mini and have the smaller form factor with the 3-4" pad option, or the PC w/ 3" BP with the...

Hi Mark,

I believe I did run across one of your threads where you placed the padding tape around the shroud, great idea by the way and I am sure to adopt it when I decide which 3" route I decide...

That is also a great idea. Luckily I am still doing the due diligence to see which 3" pad capable polisher I plan to purchase. Thanks again for the info and insight! :props:

Thanks for the speedy reply, guess I will just have to get the LC flat foam 3" for now.

Hello,

Long time lurker here, I been looking into a smaller polisher using a 3" pad to go with my 5" Pad Flex 3401. I haven't quite figured out which polisher to go with (PC7424, Rupes Mini, Flex...