I've tried #7 a few times and never thought it did anything special to the paint. Heck I even tried it on the hood of my Kubota tractor.
Then again I've never used it on paint that bad. To me it...
I tried the APC sprayed on to a Mister Clean Magic Eraser followed by some detail spray method. Still left a few streaks. Took a damp zap cloth followed with a dry microfiber and cleaned it right up....
When I was at one of my re-certification classes required by Generac, I asked a similar question and the answer was don't use it to power anything that costs more than the generator.
Decided to give HD Speed a fourth try and take some of Mike Phillips advise. Decontaminated the rear the the 2007 CRV and ran my clay mitt over the panel.
Using my PC which is set up for 3" pads...
I've used both and BF is hands down a lot more user friendly. I tried Reload every way you can and would still end up with streaks. Have yet to be able to get BF to streak.
I used BF as a dying...
Do yourself a favor and pick up a DA. You can get a GG6 for 150.00. They even sell them at Autozone.
Then figure out where your swirls are coming from, wash and drying technique? Or your free...
I just watched the HD Speed video and he used more product than I did and it just wiped right off, mine stuck to the paint like glue.
May have to give them a call.
I agree that's why I removed it right away yesterday. And I thought by only using 4 dime sized spots that this would be using less product. Also not doing the whole car as I said just testing doing...
I decided to give HD Speed another try this morning before the sun came up over the trees. Humidity on the high side. Used a new LC white pad again and only put 4 dime size spots on the pad to start...
I prime the pad like I would any polish to start with, then four dime sized there after. Wipe off with a Gold Plush Jr. Four passes in about a 2x2 section. I used this product the same as any AIO I...
So I decided to get some HD Speed and give it a try per all the internet hype. Applying with a LC white pad to a door panel on a 2007 CRV. Everything went as I've read, long work time and little to...
I've been using BF SIO2 since the beginning of May. Unlike Reload never had an issue with streaking. Just like others can't get it to streak. Spray the microfiber then a spray or two on the panel and...
I have one of the Flex cordless polishers. So far used to apply AIO's and sealants. Pretty much have to run it on speed 6 or close to it or the weight of it will stop it from spinning. I bought it...