Because I'm not planning on removing the wood from the interior, lots of taping and covering will be involved - and likely a 3" backing plate with smaller pads than what I have now (6").
Wow...no, I did not know that! Thanks for the update. Does he post on a forum sponsored by 3D? I'm at their site and don't see a link to a forum, but I do see plenty of social media stuff and videos...
Thanks. Yeah, I do plan on keeping my car for another 5 years or possibly more, so I think it's worth it. I know the films have gotten better over time. I figure, instead of that cutoff less than...
I have some swirl (not sure ### the last owner did...) and hazing on the interior wood trim of my car. Is there anything that can be done about that short of having the wood trim replaced? It has...
On this same topic, not to hijack the thread but it's been dormant for a while - I have some 3M paint protection film on my 2014 Benz, and Mike, you had mentioned maybe don't go too abrasive on it...
The damage on my panels isn't nearly as bad as the damage in the first photo of the black paint above. There are significant swirls even after a couple attempts to mitigate. After reading the posts...
This is great info. All the work I've been doing lately is to my 8 year old daily driver, a Benz E350 with black paint and a LOT of swirl. I haven't got all the scratches and swirl out yet but have...
Thank you! I did not catch the name of the tape that Mike was using on the Chevelle in the Test Spot video, want to be careful not to just use what's laying around.
Thank you, this is more what I was looking for. Seems there's a lot of different methods on the forum but I'm happy to use some purpose-specific products. I did see Mike's video on test spotting...
Wow. I should have watched this before the last two Saturdays spent with my Griot's buffer. I'm only halfway in and will watch the rest, but I did not prime the orange pads. Otherwise I think I did...
I did try a regular clay bar that didn't have much effect on the glass - may have improved it a little but not much. I know there are glass "cutting" pads out there so I just assumed a polish pad, by...
I will do more passes this weekend. I'm assuming since I just clay-barred the whole car a few days ago, I don't need to repeat that, just give it a good wash and buff away, then add wax on the panels...
Thank you...so when I attempt again, should I use the rubbing compound first w/ the orange pad given it may need that extra level of aggression, or do you mean just use the finishing polish and white...
To clarify: I did at least 3-4 passes per section initially, then went back and did the same (sometimes more than 3-4 passes) on the second attempt...I did not just pass by the area once and not go...
Glen, after reading your most recent reply again, I think what I need to do is be more vigilant and just use finishing polish next time w/ the white pad on the finer scratches, go slow, go over them...
Wow - it's been a long time but I finally, finally got around to using all this stuff. Yesterday I used the Griot's random orbital after a good wash and clay bar treatment - I used the Mothers...
My friend got a Black and Decker WP900. It comes with a 6" backing plate. Do you know if this 5" plate will work in its place? I can't find any info about it in the docs for the buffer that I can...
The CCS pads are on their way, and while it seems flat would work just fine, I'm going to try this out with the orange and white CCS pads on my Benz's black paint....