Search:

My dryers low setting generates approx 140F on low. Thinking from other areas I have read that around 140F+ is where heat can start ruining microfiber???

Pretty much line or air dry my micro...

20mm DA Polisher + 5.5" pad (7/8" LC orange) + Speed 6, Excess Force = Helicopter/Grenade.

Does this sound about right/bad/problematic. Or are others getting away with speed 6 on a thin orange...

First time I will be applying ceramic.

Does IPA wipedown remove polish remnants/oils fully (looking at using 20% ipa wipedown solution).

Or even with a good IPA wipedown can some polish...

Two Coats it is!!!

Somedays I wish I owned a rat rod...... but then would probably be the exact opposite and be researching/obsessing on how to best create/add patina :wowwow:!

Know a second layer ensures coverage but how much does a second layer add in additional gloss or durability (avalonking).

I am not a professional, just an enthusiast. Know sealants layer and...

Have been washing in warm water of my washer, but wanting to wash in hot. My washer warm setting is actually fairly cool/cold, my next step up is only hot.

I Understand drying hot ruins/melts...

Cant find anywhere online. Understand it is definitely a polish/abrasive............. but wondering if it has:

(1.) Anything extra in it to make it worthwhile different than a straight polish.
...

I am just a home gamer, finally got brave enough to do polish with a DA (thanks to much I have learned here). Great results got many old water spots off (swirl, etc). I swear water spots are a bane...

This helps! went to Settings / General Settings / Number of Posts to Show Per Page (now set at 40)

Here is an example:

On this topic/thread (see link below) the last post was by axel06 on thread page 8. When I am on thread page 1 I would like to be able to print all the thread pages (1-8) in...

Wanting to print a long forum thread with 21 pages. Any way to print all at once instead of having to go in page by page to print.

Sorry if this is in wrong forum, not finding correct forum to...

Thanks for the welcome!

Thats Stunning!!!!!!!!! I am in major Hellcat Envy mode!

Noting your combo to my Google Drive: Lake Country Blue SDO Pads & 3D ONE as the compound & then a simple...

Know they are both polymer sealants (read much rumors of being mostly pretty similar). Just switched over to Duragloss polish and coated with 601/111.

Have quite a bit of Z6 left. Just wanting...

I am mostly just a home gamer, finally got me feet wet and enough nerve from this forum and youtube to try DA polishing my own ride. Had too many water spots that were driving me nuts, would not...

Thanks Everyone, saves me one unnecessary step of crazy! Went from polish to sealant (no ipa wipedown, or rewash).

Understand might turn them glossy. Would it be harmful to them them or make them blotchy, believe they are outside the clear coat.

Thanks!

I did go ahead and tape them off this time.

Is it ok to DA polish over OEM striping [ Dodge Challenger ]. Stripe is OEM, thinking the stripe is over the clear (not under, not sure). Strip is flat black.

Or best to tape it off.
...

After DA polishing and towling Meguiars 205 off the surface is it pretty much ok to then go straight to sealant?

Or is it recommended to give it some sort of re-wash (dawn) or IPA wipe down as...

Will be using Duragloss 601/111. Understand will help with durability & cure time and a surface prep. Will be using the 601/111 (1:4) combo on the first coat for sure. My question comes in when...