Hi
I can't find any video on using the curved foam LC pads. I bought some of the gold jeweling pads with the recessed area in the back not knowing they were curved on the face of the pad. I tried using them on my flex PE-14 and it was a disaster. Very hard to control. Are you supposed to run these on edge? I am a beginner with the rotary so I am only using the PE-14 for final jeweling with menz final finish 3800. Maybe these are for pros only?

Does LC make a flat pad with the recessed area on the back for the backing plate? That is what I was after as I have trouble getting the pads centered.

Thanks


Sent from my iPhone using Tapatalk