Re: Microfiber Cutting Pads
Yes, I have done a complete car with one pad. I clean the pad after every pass with an air compressor.
Re: Microfiber Cutting Pads
cleaning the pads more often is best for these pads because once the fibers on the pads starts to stick to each other, the cutting ability will be less.
if you don't access to an air compressor like I am, you can use a cleaning brush for foam pads to re-fluff the fibers.
good luck
Re: Microfiber Cutting Pads
If the paint has been deconed properly, one pad can work. I actually prefer using a brush to compressed air, but that's just me. I clean the pad every time I finish a section, before I load up more compound. I also spritz with Poorboy's Spray and Wipe every third or fourth time as well.