Re: Backing plate stud height and diameter for 5/16" thread.
Quote:
Originally Posted by
mengelhardt
Mike, I'm thinking it is a coarse thread too, but I was just looking at the buffdaddy site, and according to his site, it's a 5/16-24 thread......
If his site is correct, that would be a fine thread, and we'd be wrong...
I'm not with my detailing supplies, so I can't check for sure.
That's probably correct, Kevin is always very accurate I his writing. Not that I'm not but sometimes I simply type faster than I think.
Just walked out to the garage and looked at the stud on an LC DA Backing Plate and it is in fact fine thread.
:)
Re: Backing plate stud height and diameter for 5/16" thread.
Quote:
Originally Posted by
Buracho
I hope to share it here if it ia a success.
Can you help me out?
Not sure what you're working on but if it's going to be a retail product the correct procedure to market it on this forum would be to first get it into the AG store and that process is to send your info to
info@autogeek.net
The information is then routed to the appropriate department and if there is any interest that department will contact you.
:)
Re: Backing plate stud height and diameter for 5/16" thread.
Quote:
Originally Posted by
FUNX650
Thanks Bob.I think that settels it.:xyxthumbs:
Re: Backing plate stud height and diameter for 5/16" thread.
Quote:
Originally Posted by
Mike Phillips
Not sure what you're working on but if it's going to be a retail product the correct procedure to market it on this forum would be to first get it into the AG store and that process is to send your info to
info@autogeek.net
The information is then routed to the appropriate department and if there is any interest that department will contact you.
:)
Thanks for your help Mike.
It is nothing major just a home experiment hopefully to make buffing easier, hopefully :)
Non the less i will make sure to follow your advice. I appreciate it.
Re: Backing plate stud height and diameter for 5/16" thread.
My work will be complete with additional measurements from you guys,
Height and Thickness/diameter.
that would be awesome :)
Re: Backing plate stud height and diameter for 5/16" thread.
5/16 - 24 I know because I made a backing plate extension 2 weeks ago
Re: Backing plate stud height and diameter for 5/16" thread.
Quote:
Originally Posted by
thesilverone
5/16 - 24 I know because I made a backing plate extension 2 weeks ago
Thanks thesilverone, Any idea of the height? Without yor mod i mean.
Re: Backing plate stud height and diameter for 5/16" thread.
It's 5/16-24 Thread and about 7/16" long.
That's measured without the compression washer in place.
I measured both a meguiars and a Lake Country backer, both were the same length.
Re: Backing plate stud height and diameter for 5/16" thread.
Quote:
Originally Posted by
mengelhardt
It's 5/16-24 Thread and about 7/16" long.
That's measured without the compression washer in place.
I measured both a meguiars and a Lake Country backer, both were the same length.
Awesome! Thanks very much bro.