What did you do today non-detailing related?

**PaulMys** · 02-17-2021, 07:34 PM

Originally Posted by minerigger

Unless you drive and older Silverado in which case they don’t go far enough to stay. Design flaw was fixed in 07...I have an 06. Go figure eh

Sent from my iPhone using Tapatalk

My God. Lol

**VISITOR** · 02-17-2021, 07:46 PM

Annual 6 month dental cleaning and changed the grease in my GG6.

**PaulMys** · 02-17-2021, 08:25 PM

Originally Posted by VISITOR

Annual? 6 month? dental cleaning and changed the grease in my GG6.

Well which one is it, Allen?? Lol

**VISITOR** · 02-18-2021, 12:19 AM

Originally Posted by PaulMys

Well which one is it, Allen?? Lol

it was my 6 month cleaning/check up for the teeth..

and then later i repacked one of the GG6's with this grease for the first time. i was bored in the moment and needed something to do...

**pro 4x** · 02-18-2021, 12:11 PM

Ran chemical cleaners thru the clothes washer and dish washer. Keep them clean.

**2black1s** · 02-18-2021, 12:51 PM

It's still early here so I'm just getting started... Did my daily 45-minute fitness routine. Put on my hernia truss LOL. Ate a banana. And now I'm sitting at this keyboard.

**dragan75** · 02-18-2021, 03:23 PM

by for 1300 eu

Sent from my SM-G973F using Tapatalk

**2black1s** · 02-22-2021, 05:47 PM

Just finished designing/drawing a bike rack to mount on a small flatbed trailer for a "paying" friend. It will also fit in the bed of a full-size pickup.

All of the materials are on-hand and fabrication will begin tomorrow.

What did you do today non-detailing related?-bra1wc-jpg

What did you do today non-detailing related?-bra1-jpg

What did you do today non-detailing related?-bra2-jpg

What did you do today non-detailing related?-bra3-jpg

What did you do today non-detailing related?-bra4-jpg

What did you do today non-detailing related?-opt1-1-jpg

What did you do today non-detailing related?-opt1-2-jpg

What did you do today non-detailing related?-opt1-3-jpg

**PaulMys** · 02-22-2021, 05:50 PM

Originally Posted by 2black1s

Just finished designing/drawing a bike rack to mount on small flatbed trailer for a "paying" friend. It will also fit in the bed of a full-size pickup.

All of the materials are on-hand and fabrication will begin tomorrow.

Well now this definitely needs its own thread!!

**2black1s** · 02-23-2021, 06:21 PM

Got everything rough cut for the bike rack.

Plywood details... 1.5 hours

What did you do today non-detailing related?-20210223_112210resized-jpg

2 x 4 details... 2.5 hours.
That includes truing and straightening. The 2-by's ended up at 1 3/8 x 3 1/4 after straightening. Now I just need to make a few minor dimensional calculations as the drawing was created assuming nominal size 2 x 4s (1 1/2 x 3 1/2); which by-the-way never turns out to be the case.