Inside Griot's Garage

[rangerbay]

I kind of want the gg3 now with the 2in pads.

I have it, and its a fantastic little machine. The 2" pads really enhance the performance, and add lots of versatility to an already great machine.

Bill

[WRAPT C5Z06]

I wouldn’t bother with anything other than the 2” pads on the GG 3”. The 3” GG DA works a lot better with 2” pads.


Sent from my iPhone using Tapatalk

[Klasse Act]

I applied Griot's Black Shine last Sat and the shine toned down and here they are after tire cleaner dwelling and being sprayed off and wiped dry.

First pic is freshly applied last Sat and the next pic is today after cleaning, looks great! It's like two finishes in one. It may say high gloss but it can be manipulated

Sent from my SM-G950U using Tapatalk

[VISITOR]

I wouldn’t bother with anything other than the 2” pads on the GG 3”.

it depends on the pad and it's profile/thickness, i've used the GG 3" FAST cutting microfiber pad and was surprised on how well it did...

[rangerbay]

it depends on the pad and it's profile/thickness, i've used the GG 3" FAST cutting microfiber pad and was surprised on how well it did...

The LC 3" thin pads also allow the machine to do its job quite well. I use the 3" sanding discs on headlights, and it knocks the crud off in just a few passes.

Bill

[minerigger]

For those that have bought these boss polishers, how do they perform with LC thinpro pads? Got a decent stash of 5.5 and looking at getting a boss 21 and the smaller plate. Do plan on getting a good selection of the boss pads but for time being.

Sent from my SM-G930V using Tapatalk

[Eldorado2k]

For those that have bought these boss polishers, how do they perform with LC thinpro pads? Got a decent stash of 5.5 and looking at getting a boss 21 and the smaller plate. Do plan on getting a good selection of the boss pads but for time being.

Sent from my SM-G930V using Tapatalk

I don't have any Thinpros that are 5.5", but judging by the 3.5" ones, they're very similar to the Boss pads minus the hole in the middle and I would assume they work and feel about the same. A bit of a firmer overall feel compared to thicker pads such as LC HDO Orbitals or Rupes pads.

[minerigger]

Visitor shot me a video link of Joe using them on his boss 21 so that's a plus. Granted they were 6.5 not 5.5 I'll just have to buy a backing plate. That said wonder how lake country would stick to the griots backing plate...i know mike says try to stay with similar makes so the hook and look works best

Sent from my SM-G930V using Tapatalk

[Klasse Act]

I use LC pads with my GG6 with no problems

Sent from my SM-G950U using Tapatalk

[minerigger]

I just want to make sure they will hold up on the boss 21 I'll be getting tomorrow or Monday

Sent from my SM-G930V using Tapatalk