Griot's 6" DA burned out

**VISITOR** · 06-23-2017, 02:19 PM

Originally Posted by WaxMaster1

But at 4-6 cars per week multiplied by 2.5 years. That's roughly 625 cars. That bad boy paid for itself quite a few times over. Cost of usage perhaps .25 cents per car. I'd buy a new one, but I'm sure some will suggest contacting Griot's for their warranty.

Originally Posted by ScottH

Always have 2 polishers - none are bullet proof. A G15 (or G21) combined with a GG6 is a nice setup and offers redundancy.

the BOSS (G15/21) and LIL' BOSS (GG6) are the dynamic duo!

**VISITOR** · 06-23-2017, 02:28 PM

if it hasn't been done already, try replacing the brushes (if it doesn't void the warranty) and see if that helps. this may be similiar on how the video below shows on replacing them...

**dlc95** · 06-23-2017, 03:08 PM

I'd take advantage of that warranty.

Having a back up isn't a bad idea either. That way you could have one set up for smaller pads, and if one goes down, that write off is there ready for use.

**ScottH** · 06-23-2017, 05:48 PM

The other advantage of having 2 machines is the ability to split the load so to speak. Polish with one, and use the other for wax or sealant application.

ScottH

**GSKR** · 06-23-2017, 06:54 PM

Originally Posted by Delsil

I have a small part time detail business where I do 4-6 cars a week. As I was buffing a vehicle yesterday it just started slowing down and eventually the pad and plate would not move or rotate at all. I did smell a small burning scent as if the buffer was overheating. Tried switching it on again while not on the car and it would start up but the pad and plate would not move and then eventually die out again after about 10 seconds. Any ideas what may be causing this? Has it finally passed away? It is about 2 years old.

I've got 5 gg6 broke the same promblem. On the hunt for more durable polisher .Looking into makita.

**Delsil** · 06-26-2017, 06:45 AM

Griot's got back to me and told me to check the electrical brushes. Sure enough one was burnt to a nub and I changed both and started right up. I do like Griot's customer service. They were very helpful.

**Delsil** · 06-26-2017, 06:45 AM

Originally Posted by Bobby B.

Griot's Garage will take care of you with the warranty on this unit. I'd recommend adding a second polisher to your arsenal for backup. The new BOSS polishers work great!

Griot's Garage Car Care, Griots Garage Detailing Products, Griotsgarage

I did think about getting the Griot's Boss G21 for heavy cutting since it has a longer MM orbital range.