-
4" backing plate??
I picked up some 5" Hybrid Power Finish pads on BOGO and they need a 4" backing plate. I tried my 3" but the pads flex too much on such a small backing plate. Any suggestions for finding a 4" backing plate for a GG6? I have seen a few DA 3 1/2" backing plates, but no DA 4". I might have to do a 4" rotary backing plate with an adapter.
Thanks!
-
Super Member
Re: 4" backing plate??
I know there is a 4" rotary backing plate. You can get an adapter. I think that pad was kind of designed for the 3401 and their 4" backing plate.
2015 F-150 Crew Cab Lariat
2016 Chevrolet Camaro 2SS
-
Post Thanks / Like - 1 Thanks, 0 Likes, 0 Dislikes
-
Super Member
Re: 4" backing plate??
Most 5" backing plates are just under 5" (4 7/8").
-
Re: 4" backing plate??
Originally Posted by
Rsurfer
Most 5" backing plates are just under 5" (4 7/8").
I tried my 5" bp... No dice
Sent from my SM-G955U using Tapatalk
-
Super Member
Re: 4" backing plate??
Dave is right about the 4" bp for the 3401. You might be better off with 5" pads as they are a standard size.
-
Re: 4" backing plate??
Originally Posted by
Rsurfer
Dave is right about the 4" bp for the 3401. You might be better off with 5" pads as they are a standard size.
I might try the rotary BP with an adapter. I have a good number of those pads.
Sent from my SM-G955U using Tapatalk
-
Super Member
Re: 4" backing plate??
Originally Posted by
wgasa84
I might try the rotary BP with an adapter. I have a good number of those pads.
Sent from my SM-G955U using Tapatalk
I don't blame you if you have a lot of pads. I just don't trust those adapters.
-
Re: 4" backing plate??
Originally Posted by
Rsurfer
I don't blame you if you have a lot of pads. I just don't trust those adapters.
Red Locktite at the BP/adapter! If it comes loose after that, I'm doing something wrong.
Sent from my SM-G955U using Tapatalk
-
Super Member
Re: 4" backing plate??
Originally Posted by
wgasa84
Red Locktite at the BP/adapter! If it comes loose after that, I'm doing something wrong.
Sent from my SM-G955U using Tapatalk
It's not that, it's the 3/16" shaft.
-
Super Member
Re: 4" backing plate??
I use this 3.5 BP" with 4" pads. Works fine.
Bookmarks