How often do you change pads during a detail?

[bigdriver4u]

I wanted to take a quick poll on the number of pads people use while detailing cars with your DA's? Are you a single pad per panel type of guy, 1 pad per side or 1 pad per car. For the sake of converstation, lets assume you are applying a 1 step product like XMT 360. Personally, I use 2-3 pads per vechicle and have a pad washer to clean pads after every other panel.

Feel free to comment outside of the scope of a 1 step process.. IE... when compounding or applying a glaze. Thanks for the info.

[Rez90]

Per step...on an average sized vehicle i'll usually use about 4 pads. Inbetween each pass i'll hit the pad with my conditioning brush to get excess product out.

In for other responses.

[RhetoricMixes]

For each step in my process whether its compounding or polishing i try to use two pads per step. Its usually do one half and then swap pads to finish the other half of the car.

[kronos]

I average about four 5.5" pads and two 4" pads per car. I also clean them after every section.

[Stang Man]

It depends, when I was green I'd use the same pad per step for the entire car!

Depending what I'm using and how bad the car is, I've been using 2-3 pads per step.

For LSP I usually only need to use one pad- by now the surface is SUPER clean and the pad is loaded, no need to swap it out and waste product.

[Waxmax]

For polishing I use 3-4, 5.5" foam pads per car, plus a few 4" and maybe an MF pad or two.......I wipe them off after each section pass and keep an eye on buildup. May spritz a little conditioner too.

[crash93ssei]

I usually use 5 or 6 5.5" CCS pads per step, or at least clean my pad thoroughly every other panel.

I find that it makes for a much easier time polishing as the pads cut faster and cleaner leaving less imperfections behind to go over again.

[oldmodman]

Now that I have a pad washer I generally use two of each type of pad. One pad is drying while the other is in use. Then I wash the one I am using and switch.

[shoeless89]

I use about 2-3 pads per step. I would probably use a new pad on every panel or every other panel if I had enough pads though.

[Danube]

2 pads p/step on average sized car.