Just curious if I am doing anything wrong
This past weekend I detailed a friend's car using the Wolfgang™ Low Profile 5.5 inch Orange Light Cutting Pads that came with the Universal Pad Washer . After I was done with one side of the truck, the pad was all black and caved in the middle. I immdeately switched to another pad and went over the same panel to make sure I didn't go too deep. The new pad came out clear with no black residue.
My questiona are:
1. What makes a pad cave in the middle? Did I go over a raised edge too much and damage the pad??
2. Wha make a pad turn black?
Bookmarks