Advice needed for how to proceed

[kingweb50]

About 2 weeks ago I started on my mother's fairly neglected exterior. I had washed, chemical/mechanical decontaminated, and was about 2/3 of the way through cutting with carpro ultra cut with plans of following up with sonax nano 3/6 polish and cquartz uk followed by gliss. When I was about 2/3 done with the compound step she had an "emergency" and needed her car back so I just went ahead and put wolfgang dgps on it and returned her car to her.

My question now is how I should proceed when she has the time to give up her car later this coming week for a couple days. Her car is parked outside and her driveway sits under a large pine type tree and I am guessing has sap on it again. I was thinking I would probably have to repeat the iron-x and clay mitt step prior to inspecting the panels I already compounded and if still seem fine I could finish the panels I didnt get to and then do whole car with the 3/6 polish with lc white pad prior to the cquartz. Does this seem like what would be best way to proceed or is there a better idea of what to do?

[The Guz]

Once you get it back you can asses what needs to be done and if you can continue where you left off. You may or my not need to go through the entire decon process.