-
Ceramic coat 2nd coat
My ceramic product recommends 12 hrs between coats. Do we see a problem. If I wait 24 hours before the 2nd coat.
Thanks
-
Super Member
Re: Ceramic coat 2nd coat
What coating is it? Should be no problem.
-
Re: Ceramic coat 2nd coat
22PLE Hpc.
Small company Detail Image sells it. It gets great review. The only bad thing is the 12 hour wait time in between coats. I was going to put coat 1 on tomorrow. Then coat 2 weds. But if 24 hrs is too long of a wait
between coats. I would wait until I have 2 consecutive days available.
Thanks
-
Super Member
Re: Ceramic coat 2nd coat
They told me 8-12 is recommended but the next day is ok. And they are not that small. I have used all of their coatings.
-
Post Thanks / Like - 0 Thanks, 1 Likes, 0 Dislikes
-
Super Member
Re: Ceramic coat 2nd coat
Originally Posted by
Luket
22PLE Hpc.
Small company Detail Image sells it. It gets great review. The only bad thing is the 12 hour wait time in between coats. I was going to put coat 1 on tomorrow. Then coat 2 weds. But if 24 hrs is too long of a wait
between coats. I would wait until I have 2 consecutive days available.
Thanks
The times i used that particular coating i waited 24hrs as back then, instructions were 12-24hrs between layers. It was quite inconvenient
-
Post Thanks / Like - 0 Thanks, 1 Likes, 0 Dislikes
-
Re: Ceramic coat 2nd coat
Originally Posted by
BudgetPlan1
The times i used that particular coating i waited 24hrs as back then, instructions were 12-24hrs between layers. It was quite inconvenient
Agree. I will do one coat today. But I can’t get to the second coat until weds. So the 24 hrs is good to hear.
-
Super Member
Re: Ceramic coat 2nd coat
If 12~24 hours is the recommended time line, I'd be tempted to wait longer until I had the time to do the job right. At that point, I would wash the car, give it another wipe down with a coating prep, and then coat. For me I could see doing one layer over a weekend and then waiting until the next to do the following layer.
-
Post Thanks / Like - 0 Thanks, 1 Likes, 0 Dislikes
-
Super Member
Re: Ceramic coat 2nd coat
I'm not a coating guy and know very little about them... but from a general engineering perspective if a product specifies 12 hours cure time between coats I would interpret that as meaning 12 hours minimum.
If there was an upper limit then the manufacturer should specify so, e.g., Second coat should be applied after xx hours but prior to xx hours.
In order to be complete, all units of measure specified need defined limits... Min/Max, +/-, from/to, approx, etc.
Failure by manufacturers to provide specified limits results in questions like the one you are asking now.
-
Super Member
Re: Ceramic coat 2nd coat
I've seen a lot of coatings and don't remember any of them stating a max cure time before 2nd coat. It's alway's the min cure time before recoating.
-
Re: Ceramic coat 2nd coat
Can’t remember which product I was looking at but it did state second coat after an hour or more than 12 (iirc) so some products do have additional instructions.
*think it was the CQuartz lite I used but can’t remember for sure.
Bookmarks