Black Molding/Trim

[hcphish]

We recently purchased a used vehicle and I am trying to get this looking good again. I am not sure what caused it but it looks some sort of chemical stain??? I know this is probably stated somewhere else but I could not find exactly what I was looking for. I did find this thread How to clean this. but it appears as though that is black rubber and not hard molding. This thread also recommended Solution Finish but this issue I have have is not on porous trim.

I have read that using a polish would fix this but I am not 100% sure (or what polish to even use). Any insight on removing these spots would be greatly appreciated, thank you!

Rear trim has the worst damage.

[Bruno Soares]

Are you talking about the B and C pillars? The black part?

[hcphish]

Correct

[Bruno Soares]

On my wife’s previous Honda Fit those were vinyl stickers that could be replaced. Is they not the case with that Honda Odyssey?

[hcphish]

If that is the case I have to admit I had no idea! Thanks for the heads up...I will have to look into that.

[Bruno Soares]

I could see the vinyl wrapped when looking from inside. If yours is the same, should be cheap to get new vinyl at dealer and replace.